On the Temperature and Chips Types in Milling of an Austenitic Stainless Steel

被引：0

作者：

Craciunoiu, Nicolae ^{[1
]}

Tarata, Daniela ^{[1
]}

Miritoiu, Cosmin ^{[1
]}

Patru, Emil Nicusor ^{[1
]}

Panduru, Dumitru ^{[1
]}

机构：

[1] Univ Craiova, Fac Mech, Craiova 200512, Romania

来源：

PROCEEDINGS OF THE 4TH INTERNATIONAL CONGRESS OF AUTOMOTIVE AND TRANSPORT ENGINEERING (AMMA 2018) | 2019年

关键词：

Temperature; Milling; Chips shape; Stainless steel; Noncontact infrared thermometer; Thermocouple; SEM electronic microscope;

D O I：

10.1007/978-3-319-94409-8_53

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

The cutting process of austenitic alloy is very difficult due to the low conductivity and tendency for built up edge. For this reason is very important to analyze the temperature and chips shape during cutting process. This paper try, based on some experimental results, to study the influence of cutting parameters on the temperature developed during the cutting process. For this, both infrared pyrometer and thermocouple are used to measure in the same time the temperature. Also the chips types is analyzed.

引用

页码：455 / 463

页数：9

共 9 条

[1] Thermal Analysis of the Chip Formation in Austenitic Stainless Steel [J].