Fouling Reduction of a Poly(ether sulfone) Hollow-Fiber Membrane with a Hydrophilic Surfactant Prepared via Non-Solvent-Induced Phase Separation

Membrane fouling is still a crucial problem, especially in applications for water treatment. When fouling takes place on membrane surfaces, it causes flux decline, leading to an increase in production cost due to increased energy demand. The selection of the right membrane material and a special treatment of the membrane are required to avoid membrane fouling. This article reports the fouling resistance of a poly(ether sulfone) (PIES) hollow-fiber membrane modified with hydrophilic surfactant Tetronic 1307. Experiments on several methods of fouling were carried out to investigate the effect of the addition of nonionic surfactant Tetronic 1307 on membrane fouling. The effectiveness of a chemical agent [sodium hypochlorite (NaCIO)] in the reduction of bovine serum albumin (BSA) deposition on the membrane surface was also evaluated. Permeation results showed that the fouling of a PES blend membrane with Tetronic 1307 was lower than that of the original PES membrane in the case of BSA filtration. A treatment with a 100 ppm NaClO solution was capable of removing BSA cake formation and effective at improving the relative permeability. The permeability of a PES blend membrane with Tetronic 1307 was almost 2 times higher than the original permeability when the membrane was treated with a 100 ppm NaClO solution because both BSA and Tetronic 1307 could be decomposed. (C) 2008 Wiley Periodicals, Inc. J Appl Polym Sci 111: 1653-1658, 2009