Liquid crystal-photopolymer composite films for label-free single-substrate protein quantitation and immunoassay

Conventional liquid crystal (LC)-based biosensing at the LC-glass interface requires the assembly of an LC cell formed by two glass substrates with an LC film sandwiched in between. As most biochemical and clinical assays are performed on a single solid substrate, the feasibility of a single-substrate biodetection platform based on a thin film of LC-photopolymer composite was explored in this study. The LC mixture, consisting of nematic LC, E7 or AY40-006, doped with a small amount (<= 5 wt%) of a photocurable prepolymer was spin-coated on a glass substrate modified with dimethyloctadecyl[3-trimethoxysilyppropyll ammonium chloride (DMOAP), a vertical alignment reagent, followed by irradiation with ultraviolet (UV) light. During the photopolymerization process, the accumulated and polymerized NOA65 at the LC-glass interface weakened the anchoring strength of DMOAP, resulting in a decrease in the pretilt angle of LC and allowing the LC molecules to be more easily disturbed in the presence of biomolecules, compared with vertically aligned LC in the absence of polymerized NOA65. Incorporating NOA65 in the LC film therefore provides a means for signal amplification. When an LC-photopolymer composite film consisting of AY40-006 and 4-wtoic NOA65 was exposed to UV at 15 mW/cm(2) for 30 s and utilized as the biosensing mesogen, the limits of detection were 1.6 x 10(-12) g/ml for the direct detection of bovine serum albumin (BSA) and 2.1 x 10(-8 )g/ml for the immunoassay of the cancer biomarker CA125, significantly lower than those detected with AY40-006 alone or AY40-006/NOA65 mixture without UV irradiation. The results from this study offer a compelling implication on the biomedical application of LC-photopolymer composites in label-free and single-substrate biodetection. (C) 2020 Optical Society of America under the terms of the OSA Open Access Publishing Agreement