Low Power Switch Mode Power Supply with High Operating Speed Employed with Efficient MTCMOS Technique

被引:0
|
作者
Gupta, Gajendra [1 ]
Mohanty, Sumit [1 ]
Akashe, Shyam [2 ]
机构
[1] ITM Univ, ECED, Gwalior, India
[2] ITM Univ, ECE, Gwalior, India
来源
JOURNAL OF ACTIVE AND PASSIVE ELECTRONIC DEVICES | 2020年 / 15卷 / 1-2期
关键词
SMPS; delay; High frequency (H.F); multi threshold voltage; CMOS Technology;
D O I
暂无
中图分类号
TM [电工技术]; TN [电子技术、通信技术];
学科分类号
0808 ; 0809 ;
摘要
In the field of electronic circuit design it is very necessary that the circuit should perform with the higher efficiency and the there should not be much delay in the circuit while operating in the tool like cadence virtuoso etc. So in this paper we are designing a new SMPS employing with the efficient power and leakage reduction technique that is MTCMOS. In the conventional circuit the Noise and leakage of the circuit is little bit high and the size and weight of the transformer is also large as compare to the proposed circuit but when we are employing the high frequency (HF) transformer the size and weight of the main transformer has reduced. Now in this paper by employing the reduction technique that MTCMOS all the parameter like Noise and leakage has been reduced up to 1.006 V/sqrt Hz and 10.18pA respectively. And the efficiency of this current paper has been improved up to 94.5 %. The 45 nm technologies are employed for the complete recreation of the proposed work at cadence virtuoso tool. And 0.7v power is supplied for enhanced design.
引用
收藏
页码:137 / 149
页数:13
相关论文
共 50 条
  • [21] Design of a Low Power High Speed ALU in 45nm Using GDI Technique and Its Performance Comparison
    Kumar, Manish
    Hussain, Md Anwar
    Singh, L. L. K.
    COMPUTER NETWORKS AND INFORMATION TECHNOLOGIES, 2011, 142 : 458 - 463
  • [22] Proposal of a switch-mode power supply by the association of an interleaved boost-flyback converter and an interleaved forward topology
    Gallo, CA
    Galelli, MT
    Coelho, EAA
    Freitas, LC
    Vieira, JB
    Farias, VJ
    APEC 2005: TWENTIETH ANNUAL IEEE APPLIED POWER ELECTRONICS CONFERENCE AND EXPOSITION, VOLS 1-3, 2005, : 1595 - 1599
  • [23] Low Power Design of a Two Bit Mangitude Comparator for High Speed Operation
    Hasan, Mehedi
    Saha, Uttam Kumar
    Hossain, Muhammad Saddam
    Biswas, Parag
    Hossein, Md. Jobayer
    Dipto, Md. Ashik Zafar
    2019 INTERNATIONAL CONFERENCE ON COMPUTER COMMUNICATION AND INFORMATICS (ICCCI - 2019), 2019,
  • [24] A High speed Low Power Adder in Dynamic logic base on Transmission Gate
    Jain, Neeraj
    Gour, Puran
    Shrman, Brahmi
    2015 INTERNATIONAL CONFERENCED ON CIRCUITS, POWER AND COMPUTING TECHNOLOGIES (ICCPCT-2015), 2015,
  • [25] Design of High-speed Power efficient full adder with Body-biasing
    Kumar, Amit
    Srivastava, Pankaj
    Pattanaik, Manisha
    2015 GLOBAL CONFERENCE ON COMMUNICATION TECHNOLOGIES (GCCT), 2015, : 655 - 660
  • [26] Performance Analysis of Dynamic Threshold MOS (DTMOS) Based 4-Input Multiplexer Switch for Low Power and High Speed FPGA Design
    Kumar, Deepak
    Kumar, Pankaj
    Pattanaik, Manisha
    SBCCI 2010: 23RD SYMPOSIUM ON INTEGRATED CIRCUITS AND SYSTEMS DESIGN, PROCEEDINGS, 2010, : 2 - 7
  • [27] Design of FIR Filter Using Low-Power and High-Speed Carry Select Adder for Low-Power DSP Applications
    Swetha, Siliveri
    Reddy, N. Siva Sankara
    IETE JOURNAL OF RESEARCH, 2024, 70 (04) : 4083 - 4096
  • [28] Design, Simulation and Development of DC Switch Mode Power Supply feeding Plasma Torch based Incinerator for Radioactive Waste Management
    Jha, Ashutosh Kumar
    Kulkarni, R. D.
    Diwan, Jyoti
    2021 6TH INTERNATIONAL CONFERENCE FOR CONVERGENCE IN TECHNOLOGY (I2CT), 2021,
  • [29] Low-Power and High-Speed Technique for logic Gates in 20nm Double-Gate FinFET Technology
    Priydarshi, A.
    Chattopadhyay, M. K.
    INTERNATIONAL CONFERENCE ON RECENT TRENDS IN PHYSICS 2016 (ICRTP2016), 2016, 755
  • [30] Low power and high write speed SEU tolerant SRAM data cell design
    Wang Li
    Zhang GuoHe
    Zeng YunLin
    Shao ZhiBiao
    SCIENCE CHINA-TECHNOLOGICAL SCIENCES, 2015, 58 (11) : 1983 - 1988