TEXTURE AND MICROSTRUCTURE OF WE54 ALLOY AFTER HOT ROLLING AND ANNEALING

被引：11
作者：
Azzeddine, Hiba [1 ]
Bradai, Djamel [1 ]
机构：
[1] USTHB, Fac Phys, Algiers 16111, Algeria
来源：
TEXTURES OF MATERIALS, PTS 1 AND 2 | 2012年 / 702-703卷
关键词：
WE54; Recrystallisation; Rolling; Texture; Grain Size;
D O I：
10.4028/www.scientific.net/MSF.702-703.453
中图分类号：
T [工业技术];
学科分类号：
08 ;
摘要：
The texture and microstructure after hot rolling and annealing of WE54 alloy was investigated using X-ray techniques and optical microscopy. WE54 alloy was hot rolled at 400 degrees C to two different reductions (20% and 53%) and then annealed at 450 degrees C for 30 minutes. These treatments resulted in a retained but much weaker basal texture with grain size almost unchanged.
引用
收藏
页码：453 / 456
页数：4
相关论文
共 12 条
  • [1] Abdessameud S, 2009, CAN METALL QUART, V48, P433, DOI 10.1179/000844309794238810
  • [2] Influence of strain path change on the rolling behavior of twin roll cast magnesium alloy
    Al-Samman, T.
    Gottstein, G.
    [J]. SCRIPTA MATERIALIA, 2008, 59 (07) : 760 - 763
  • [3] TENSILE-COMPRESSIVE YIELD ASYMMETRIES IN HIGH-STRENGTH WROUGHT MAGNESIUM ALLOYS
    BALL, EA
    PRANGNELL, PB
    [J]. SCRIPTA METALLURGICA ET MATERIALIA, 1994, 31 (02): : 111 - 116
  • [4] Influence of aging pre-treatment on the compressive deformation of WE54 alloy
    Beladi, H.
    Barnett, M. R.
    [J]. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2007, 452 (306-312): : 306 - 312
  • [5] The texture and anisotropy of magnesium-zinc-rare earth alloy sheets
    Bohlen, Jan
    Nuernberg, Marcus R.
    Senn, Jeremy W.
    Letzig, Dietmar
    Agnew, Sean R.
    [J]. ACTA MATERIALIA, 2007, 55 (06) : 2101 - 2112
  • [6] Cottam R., 2008, 15 INT C TEXT MAT IC, P501
  • [7] ODF CALCULATION BY SERIES EXPANSION FROM INCOMPLETELY MEASURED POLE FIGURES USING THE POSITIVITY CONDITION .1. CUBIC-CRYSTAL SYMMETRY
    DAHMS, M
    BUNGE, HJ
    [J]. TEXTURES AND MICROSTRUCTURES, 1987, 7 (03): : 171 - 185
  • [8] Processing and properties of Mg-6Gd-1Zn-0.6Zr Part 2. Mechanical properties and particle twin interactions
    Geng, J.
    Chun, Y. B.
    Stanford, N.
    Davies, C. H. J.
    Nie, J. F.
    Barnett, M. R.
    [J]. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2011, 528 (10-11): : 3659 - 3665
  • [9] Humphreys F., 1995, Recrystallisation and Related Annealing Phenomena
  • [10] High temperature deformations of Mg-Y-Nd alloys fabricated by different routes
    Liu, Xibo
    Chen, Rongshi
    Han, Enhou
    [J]. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2008, 497 (1-2): : 326 - 332
12