The power of glove: Soft microbial fuel cell for low-power electronics

被引:40
作者
Winfield, Jonathan [1 ]
Chambers, Lily D. [2 ]
Stinchcombe, Andrew [1 ]
Rossiter, Jonathan [3 ]
Ieropoulos, Ioannis [1 ]
机构
[1] Univ W England, Bristol Robot Lab, Bristol BS34 8QZ, Avon, England
[2] Univ Bristol, Bristol Robot Lab, Bristol BS34 8QZ, Avon, England
[3] Univ Bristol, Dept Engn Math, Bristol BS8 1TR, Avon, England
基金
英国工程与自然科学研究理事会; 比尔及梅琳达.盖茨基金会;
关键词
Microbial fuel cell; Natural rubber; Power management system; Urine; Conductive latex; Energy harvesting; ELECTRICITY-GENERATION;
D O I
10.1016/j.jpowsour.2013.10.096
中图分类号
O64 [物理化学(理论化学)、化学物理学];
学科分类号
070304 ; 081704 ;
摘要
A novel, soft microbial fuel cell (MFC) has been constructed using the finger-piece of a standard laboratory natural rubber latex glove. The natural rubber serves as structural and proton exchange material whilst untreated carbon veil is used for the anode. A soft, conductive, synthetic latex cathode is developed that coats the outside of the glove. This inexpensive, lightweight reactor can without any external power supply, start up and energise a power management system (PMS), which steps-up the MFC output (0.06-0.17 V) to practical levels for operating electronic devices (>3 V). The MFC is able to operate for up to 4 days on just 2 mL of feedstock (synthetic tryptone yeast extract) without any cathode hydration. The MFC responds immediately to changes in fuel-type when the introduction of urine accelerates the cycling times (35 vs. 50 min for charge/discharge) of the MFC and PMS. Following starvation periods of up to 60 h at 0 mV the MFC is able to cold start the PMS simply with the addition of 2 mL fresh feedstock. These findings demonstrate that cheap MFCs can be developed as sole power sources and in conjunction with advancements in ultra-low power electronics, can practically operate small electrical devices. (C) 2013 Elsevier B.V. All rights reserved.
引用
收藏
页码:327 / 332
页数:6
相关论文
共 22 条
  • [1] Continuous electricity generation at high voltages and currents using stacked microbial fuel cells
    Aelterman, Peter
    Rabaey, Korneel
    Pham, Hai The
    Boon, Nico
    Verstraete, Willy
    [J]. ENVIRONMENTAL SCIENCE & TECHNOLOGY, 2006, 40 (10) : 3388 - 3394
  • [2] Diversifying biological fuel cell designs by use of nanoporous filters
    Biffinger, Justin C.
    Ray, Ricky
    Little, Brenda
    Ringeisen, Bradley R.
    [J]. ENVIRONMENTAL SCIENCE & TECHNOLOGY, 2007, 41 (04) : 1444 - 1449
  • [3] Bi-directional electrical characterisation of microbial fuel cell
    Degrenne, N.
    Ledezma, P.
    Bevilacqua, P.
    Buret, F.
    Allard, B.
    Greenman, J.
    Ieropoulos, I. A.
    [J]. BIORESOURCE TECHNOLOGY, 2013, 128 : 769 - 773
  • [4] Electrical energy generation from a large number of microbial fuel cells operating at maximum power point electrical load
    Degrenne, N.
    Buret, F.
    Allard, B.
    Bevilacqua, P.
    [J]. JOURNAL OF POWER SOURCES, 2012, 205 : 188 - 193
  • [5] Electricity generation and treatment of paper recycling wastewater using a microbial fuel cell
    Huang, Liping
    Logan, Bruce E.
    [J]. APPLIED MICROBIOLOGY AND BIOTECHNOLOGY, 2008, 80 (02) : 349 - 355
  • [6] Ieropoulos I., 2007, BIOINSPIR BIOMIM, V2, pS83
  • [7] Ieropoulos I., 2003, P I INT S IM AN ART, P191
  • [8] Ieropoulos I., 2010, ARTIF LIFE, P733
  • [9] Microbial fuel cells based on carbon veil electrodes: Stack configuration and scalability
    Ieropoulos, Ioannis
    Greenman, John
    Melhuish, Chris
    [J]. INTERNATIONAL JOURNAL OF ENERGY RESEARCH, 2008, 32 (13) : 1228 - 1240
  • [10] Development of a tubular microbial fuel cell (MFC) employing a membrane electrode assembly cathode
    Kim, Jung Rae
    Premier, Giuliano C.
    Hawkes, Freda R.
    Dinsdale, Richard M.
    Guwy, Alan J.
    [J]. JOURNAL OF POWER SOURCES, 2009, 187 (02) : 393 - 399