Influence of the thermal-spray procedure on the properties of a nickel-chromium coating

被引：34

作者：

Higuera, V ^{[1
]}

Belzunce, FJ ^{[1
]}

Carriles, A ^{[1
]}

Poveda, S ^{[1
]}

机构：

[1] Univ Oviedo, Gijon 33203, Spain

来源：

JOURNAL OF MATERIALS SCIENCE | 2002年 / 37卷 / 03期

关键词：

Fatigue; Power Plant; Tensile Test; Combustion Chamber; Fatigue Test;

D O I：

10.1023/A:1013742213115

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

A modified NiCr coating was thermal-spray projected using different procedures (flame, plasma, HVOF and HFPD) onto stainless steel specimens. This type of coating is normally used as protection against heat, corrosion and erosion actions encountered in superheater and reheater tubes in power plant boilers. The microstructures, porosities, oxide contents and microhardnesses of the coatings were determined. Thermal fatigue tests under an atmosphere similar to power plant service conditions were conducted in an experimental combustion chamber and, finally, the adhesion between the substrate and the coating layer was evaluated by means of tensile tests. The results obtained are discussed, with special attention being paid to the specific characteristics of the different spraying procedures. (C) 2002 Kluwer Academic Publishers.

引用

页码：649 / 654

页数：6