Case study on solar water heating for flat plate collector

被引：44

作者：

Hashim, Walaa Mousa ^{[1
]}

Shomran, Ali Talib ^{[2
]}

Jurmut, Hasan Ali ^{[2
]}

Gaaz, Tayser Sumer ^{[2
]}

Kadhum, Abdul Amir H. ^{[3
]}

Al-Amiery, Ahmed A. ^{[4
]}

机构：

[1] Univ Technol Baghdad, Baghdad 10001, Iraq

[2] Al Furat Al Awsat Tech Univ, Tech Coll Al Musaib, Dept Machinery Equipment Engn Tech, Al Musaib 51009, Babil, Iraq

[3] Univ Kebangsaan Malaysia, Dept Chem & Proc Engn, Fac Engn & Built Environm, Bangi 43600, Selangor, Malaysia

[4] Univ Technol Baghdad, Energy & Renewable Energies Technol Ctr, Baghdad 1000, Iraq

来源：

CASE STUDIES IN THERMAL ENGINEERING | 2018年 / 12卷

关键词：

Flat plate collector; Thermal performance; Solar water heated; NANO-FLUID; PERFORMANCE; SYSTEM;

D O I：

10.1016/j.csite.2018.09.002

中图分类号：

O414.1 [热力学];

学科分类号：

摘要：

This paper describes performance solar water heating for flat plate collector. The system of thermal performance designed for dimensions 125 x 110 cm and width 25 cm, in such a way that fluid can flow from inlet to outlet through pipe with longer is 15.9 m, designed as lope square pattern, used the water as fluid flow working with two different flow rate (5.3 and 6.51 L/min). The experiments were carried out under the University of Technology, conditions of Baghdad, Iraq. The result shows that the water at flow rate 5.3 L/min heated more than the flow rate 6.51 L/min, which causes the higher efficiency and effectiveness of the collector, so the maximum temperature was (51.4 degrees C and 49 degrees C) at flow rate (5.3 L/min and 6.51 L/min) respectively. The main conclusion is that used this system to heated the water and then used in-house, building and other purposes.

引用

页码：666 / 671

页数：6

共 21 条

[1]

[Anonymous], 16 INT WAT TECHN C I

[2] Efficiency improvement of flat plate solar collector using reflector [J].