Design of a thermally integrated bioethanol-fueled solid oxide fuel cell system integrated with a distillation column

被引:7
作者
Jamsak, W. [2 ]
Douglas, P. L. [1 ]
Croiset, E. [1 ]
Suwanwarangkul, R. [3 ]
Laosiripojana, N. [4 ]
Charojrochkul, S.
Assabumungrat, S. [2 ]
机构
[1] Univ Waterloo, Dept Chem Engn, Waterloo, ON N2L 3G1, Canada
[2] Chulalongkorn Univ, Ctr Excellence Catalysis & Catalyt React Engn, Dept Chem Engn, Fac Engn, Bangkok 10330, Thailand
[3] Thammasart, Sch Biochem Engn & Technol, Sirindhorn Int Inst Technol, Pathum Thani 12121, Thailand
[4] King Mongkuts Univ Technol, Joint Grad Sch Energy & Environm, Thonburi, Thailand
关键词
Solid oxide fuel cell; Integration; Bioethanol; Distillation unit; Heat exchanger network; THERMODYNAMIC ANALYSIS; HYDROGEN-PRODUCTION; EXERGY ANALYSIS; SOFC SYSTEM; ETHANOL; SIMULATION; ENERGY; STACK;
D O I
10.1016/j.jpowsour.2008.09.036
中图分类号
O64 [物理化学(理论化学)、化学物理学];
学科分类号
070304 ; 081704 ;
摘要
Solid oxide fuel cell systems integrated with a distillation column (SOFC-DIS) have been investigated in this study. The MER (maximum energy recovery) network for SOFC-DIS system under the base conditions (C-ErOH 25%. EtOH recovery = 80%, V = 0.7 V, fuel utilization = 80%, T-SOFC = 1200 K) yields Q(Cmin) = 73.4 and Q(Hmin) = 0 kW To enhance the performance of SOFC-DIS, utilization of internal useful heat sources from within the system (e.g. condenser duty and hot water from the bottom of the distillation column) and a cathode recirculation have been considered in this study. The utilization of condenser duty for preheating the incoming bioethanol and cathode recirculation for SOFC-DIS system were chosen and implemented to the SOFC-DIS (CondBio-CathRec). Different MER designs were investigated. The obtained MER network of CondBio-CathRec configuration shows the lower minimum cold utility (Q(Cmin)) of 55.9 kW and total cost index than that of the base case. A heat exchanger loop and utility path were also investigated. It was found that eliminate the high temperature distillate heat exchanger can lower the total cost index. The recommended network is that the hot effluent gas is heat exchanged with the anode heat exchanger, the external reformer, the air heat exchanger, the distillate heat exchanger and the reboiler, respectively. The corresponding performances of this design are 40.8%, 54.3%, 0.221 W cm(-1) for overall electrical efficiency, Combine Heat and Power (CHP) efficiency and power density, respectively. The effect of operating conditions on composite curves on the design of heat exchanger network was investigated. The obtained composite curves can be divided into two groups: the threshold case and the pinch case. it was found that the pinch case which TSOFC = 1173 K yields higher total cost index than the CondBio-CathRec at the base conditions. It was also found that the pinch case can become a threshold case by adjusting split fraction or operating at lower fuel utilization. The total cost index of the threshold cases is lower than that of the pinch case. Moreover, it was found that some conditions can give lower total cost index than that of the CondBio-CathRec at the base conditions. (c) 2008 Elsevier B.V. All rights reserved.
引用
收藏
页码:190 / 203
页数:14
相关论文
共 50 条
  • [41] Performance of Membrane-Assisted Solid Oxide Fuel Cell System Fuelled by Bioethanol
    Sukwattanajaroon, Vorachatra
    Charojrochkul, Sumittra
    Kiatkittipong, Worapon
    Arpornwichanop, Amornchai
    Assabumrungrat, Suttichai
    ENGINEERING JOURNAL-THAILAND, 2011, 15 (02): : 53 - 66
  • [42] Greenhouse gas emission and exergy analyses of an integrated trigeneration system driven by a solid oxide fuel cell
    Chitsaz, Ata
    Mahmoudi, S. Mohammad S.
    Rosen, Marc A.
    APPLIED THERMAL ENGINEERING, 2015, 86 : 81 - 90
  • [44] Thermodynamic modelling of an integrated solid oxide fuel cell and micro gas turbine system for desalination purposes
    Hosseini, Mehdi y
    Dincer, Ibrahim
    Ahmadi, Pouria
    Avval, Hasan Barzegar
    Ziaasharhagh, Masoud
    INTERNATIONAL JOURNAL OF ENERGY RESEARCH, 2013, 37 (05) : 426 - 434
  • [45] Numerical analysis of a solid oxide fuel cell system integrated with a hybrid desiccant cooling system
    Kim, Siwoong
    Kim, Taebeen
    Oh, Seunghun
    Ham, Jinyoung
    Kang, Sanggyu
    ENERGY CONVERSION AND MANAGEMENT, 2023, 296
  • [46] Investigation on performance of an integrated solid oxide fuel cell and absorption chiller tri-generation system
    Yu, Zeting
    Han, Jitian
    Cao, Xianqi
    INTERNATIONAL JOURNAL OF HYDROGEN ENERGY, 2011, 36 (19) : 12561 - 12573
  • [47] Carbon monoxide-fueled solid oxide fuel cell
    Homel, Michael
    Gur, Turgut M.
    Koh, Joon Ho
    Virkar, Anil V.
    JOURNAL OF POWER SOURCES, 2010, 195 (19) : 6367 - 6372
  • [48] Artificial Intelligence Approach in Gasification Integrated Solid Oxide Fuel Cell Cycle
    Sezer, Senem
    Kartal, Furkan
    Ozveren, Ugur
    FUEL, 2022, 311
  • [49] Efficient heat allocation in the two-step ethanol steam reforming and solid oxide fuel cell integrated process
    Tippawan, Phanicha
    Im-Orb, Karittha
    Arpornwichanop, Amornchai
    ENERGY, 2017, 133 : 545 - 556
  • [50] Off-design performance analysis for an integrated system of solid oxide fuel cell and supercritical carbon dioxide Brayton cycle with CO2 capture
    Liu, Zekun
    Wang, Yutian
    Xie, Meina
    He, Xianya
    Zhang, Wenxian
    Xie, Shan
    Zhao, Yingru
    ENERGY CONVERSION AND MANAGEMENT, 2023, 292