Design of a thermally integrated bioethanol-fueled solid oxide fuel cell system integrated with a distillation column

被引:7
作者
Jamsak, W. [2 ]
Douglas, P. L. [1 ]
Croiset, E. [1 ]
Suwanwarangkul, R. [3 ]
Laosiripojana, N. [4 ]
Charojrochkul, S.
Assabumungrat, S. [2 ]
机构
[1] Univ Waterloo, Dept Chem Engn, Waterloo, ON N2L 3G1, Canada
[2] Chulalongkorn Univ, Ctr Excellence Catalysis & Catalyt React Engn, Dept Chem Engn, Fac Engn, Bangkok 10330, Thailand
[3] Thammasart, Sch Biochem Engn & Technol, Sirindhorn Int Inst Technol, Pathum Thani 12121, Thailand
[4] King Mongkuts Univ Technol, Joint Grad Sch Energy & Environm, Thonburi, Thailand
关键词
Solid oxide fuel cell; Integration; Bioethanol; Distillation unit; Heat exchanger network; THERMODYNAMIC ANALYSIS; HYDROGEN-PRODUCTION; EXERGY ANALYSIS; SOFC SYSTEM; ETHANOL; SIMULATION; ENERGY; STACK;
D O I
10.1016/j.jpowsour.2008.09.036
中图分类号
O64 [物理化学(理论化学)、化学物理学];
学科分类号
070304 ; 081704 ;
摘要
Solid oxide fuel cell systems integrated with a distillation column (SOFC-DIS) have been investigated in this study. The MER (maximum energy recovery) network for SOFC-DIS system under the base conditions (C-ErOH 25%. EtOH recovery = 80%, V = 0.7 V, fuel utilization = 80%, T-SOFC = 1200 K) yields Q(Cmin) = 73.4 and Q(Hmin) = 0 kW To enhance the performance of SOFC-DIS, utilization of internal useful heat sources from within the system (e.g. condenser duty and hot water from the bottom of the distillation column) and a cathode recirculation have been considered in this study. The utilization of condenser duty for preheating the incoming bioethanol and cathode recirculation for SOFC-DIS system were chosen and implemented to the SOFC-DIS (CondBio-CathRec). Different MER designs were investigated. The obtained MER network of CondBio-CathRec configuration shows the lower minimum cold utility (Q(Cmin)) of 55.9 kW and total cost index than that of the base case. A heat exchanger loop and utility path were also investigated. It was found that eliminate the high temperature distillate heat exchanger can lower the total cost index. The recommended network is that the hot effluent gas is heat exchanged with the anode heat exchanger, the external reformer, the air heat exchanger, the distillate heat exchanger and the reboiler, respectively. The corresponding performances of this design are 40.8%, 54.3%, 0.221 W cm(-1) for overall electrical efficiency, Combine Heat and Power (CHP) efficiency and power density, respectively. The effect of operating conditions on composite curves on the design of heat exchanger network was investigated. The obtained composite curves can be divided into two groups: the threshold case and the pinch case. it was found that the pinch case which TSOFC = 1173 K yields higher total cost index than the CondBio-CathRec at the base conditions. It was also found that the pinch case can become a threshold case by adjusting split fraction or operating at lower fuel utilization. The total cost index of the threshold cases is lower than that of the pinch case. Moreover, it was found that some conditions can give lower total cost index than that of the CondBio-CathRec at the base conditions. (c) 2008 Elsevier B.V. All rights reserved.
引用
收藏
页码:190 / 203
页数:14
相关论文
共 50 条
  • [1] Thermodynamic assessment of solid oxide fuel cell system integrated with bioethanol purification unit
    Jamsak, W.
    Assabumrungrat, S.
    Douglas, P. L.
    Croiset, E.
    Laosiripojana, N.
    Suwanwarangkul, R.
    Charojrochkul, S.
    JOURNAL OF POWER SOURCES, 2007, 174 (01) : 191 - 198
  • [2] Design and Evaluation of a Metal-Supported Solid Oxide Fuel Cell Vehicle Power System with Bioethanol Onboard Reforming
    Ma, Shuai
    Hu, Xiaoying
    Zhao, Ying
    Wang, Xiaoqiang
    Dong, Changqing
    ACS OMEGA, 2021, 6 (43): : 29201 - 29214
  • [3] Thermodynamic modeling of an integrated biomass gasification and solid oxide fuel cell system
    Jia, Junxi
    Abudula, Abuliti
    Wei, Liming
    Sun, Baozhi
    Shi, Yue
    RENEWABLE ENERGY, 2015, 81 : 400 - 410
  • [4] Performance of an Integrated Microtubular Fuel Reformer and Solid Oxide Fuel Cell System
    Izzo, John R., Jr.
    Peracchio, Aldo A.
    Chiu, Wilson K. S.
    JOURNAL OF FUEL CELL SCIENCE AND TECHNOLOGY, 2010, 7 (03): : 0310171 - 0310179
  • [5] High efficiencies with low fuel utilization and thermally integrated fuel reforming in a hybrid solid oxide fuel cell gas turbine system
    Chen, Hao
    Yang, Chen
    Zhou, Nana
    Harun, Nor Farida
    Oryshchyn, Danylo
    Tucker, David
    APPLIED ENERGY, 2020, 272
  • [6] Thermodynamic analysis of an integrated reversible solid oxide fuel cell system
    Pan, Jun
    Yang, Yiping
    Lei, Jinyong
    Huang, Xurui
    ENERGY CONVERSION AND MANAGEMENT-X, 2023, 20
  • [7] An Energy Integrated Solid Oxide Fuel Cell System: Modeling and Simulation
    Wutthithanyawat, Chananchai
    Srisiriwat, Nawadee
    ADVANCED RESEARCH IN MATERIAL SCIENCE AND MECHANICAL ENGINEERING, PTS 1 AND 2, 2014, 446-447 : 777 - +
  • [8] Performance assessment and optimization of an integrated solid oxide fuel cell-gas turbine cogeneration system
    Guo, Yinglun
    Yu, Zeting
    Li, Guoxiang
    Zhao, Hongxia
    INTERNATIONAL JOURNAL OF HYDROGEN ENERGY, 2020, 45 (35) : 17702 - 17716
  • [9] Integrated fuel cell system with tubular solid oxide fuel cells
    Boersma, RJ
    Sammes, NM
    Fee, C
    JOURNAL OF POWER SOURCES, 2000, 86 (1-2) : 369 - 375
  • [10] Thermodynamic analysis of an integrated power generation system driven by solid oxide fuel cell
    Wang, Jiangfeng
    Yan, Zhequan
    Ma, Shaolin
    Dai, Yiping
    INTERNATIONAL JOURNAL OF HYDROGEN ENERGY, 2012, 37 (03) : 2535 - 2545