Design of low-noise CMOS transimpedance amplifier

Purpose - The purpose of this paper is to design a very low-noise transimpedance amplifier (TIA) for a novel multi-pixel CMOS photon detector which performs secondary electron (SE) detection in the scanning electron microscope (SEM). Design/methodology/approach - The TIA, which is implemented with three-stage push-pull inverters, is optimised using a nomograph technique developed in MATLAB. SPICE simulations are conducted to verify the results generated from MATLAB. Important performance figures are obtained experimentally and these measurements are compared with simulation results. Findings - A low-noise TIA fabricated in a standard 0.35 mu m CMOS technology was tested. Experimental results obtained show that the TIA connected to a photodiode with a junction capacitance of 0.8 pF can carry out its task effectively with a transimpedance gain of 126.9 dB Omega, a bandwidth of 9.8 MHz, an input-referred noise of 2.50 x 10(-13) A/root Hz and an SNR of 12.8. The power consumption of the TIA was 49.3 mW. These encouraging results have exhibited the potential of the circuit for use in the CMOS photon detector. Originality/value - This paper presents a low-noise transimpedance amplifier that is highly suitable to be used as a critical constituent block for the CMOS photon detector which aims to take over the role of photomultiplier tube in SE detection in the SEM. Solid-state approaches have recently been reinvigorated for improving certain aspects of SE detection in scanning electron microscopy and this work has supported and contributed to the trend.