A novel perspective process for alumina extraction from coal fly ash via potassium pyrosulfate calcination activation method

被引:22
|
作者
Guo, Chunbin [1 ]
Zhao, Lu [1 ]
Yang, Jianlin [1 ]
Wang, Kehan [1 ]
Zou, Jingjing [2 ]
机构
[1] Liaoning Tech Univ, Dept Mat Sci & Engn, Fuxin 123000, Liaoing, Peoples R China
[2] Liaoning Tech Univ, Dept Environm Sci & Engn, Fuxin 123000, Liaoing, Peoples R China
基金
中国国家自然科学基金;
关键词
Coal fly ash; Alumina extraction; Potassium pyrosulfate; Response surface methodology; Box-Behnken design; Al-27; MAS-NMR; BOX-BEHNKEN DESIGN; CIRCULATING FLUIDIZED-BED; PROPANE DEHYDROGENATION; OXIDATIVE DEHYDROGENATION; CONJUGATE ADSORBENT; HYDROGEN SULFATE; WATER; OPTIMIZATION; KINETICS; PT-SN/GAMMA-AL2O3;
D O I
10.1016/j.jclepro.2020.122703
中图分类号
X [环境科学、安全科学];
学科分类号
08 ; 0830 ;
摘要
Alumina extraction is considered as one of the promising trends for the value-added use of coal fly ash (CFA). In this study, a moderate potassium pyrosulfate (K2S2O7) calcination activation method was used to extract alumina from CFA. The calcined conditions including X-1: K2S2O7/Al2O3 molar ratio (2-4), X-2: calcining temperature (180-220 degrees C), X-3: calcining time (2-4 h) was optimized by using response surface method based on 3-factor 3-degree Box-Behnken design. The effects of confirmed factors were fitted in a quadratic regression polynomial equation. The main and interacting influences between variables were studied by using the analysis of variance and 3D plots, respectively. The results show the alumina extraction rate was more influenced by K2S2O7/Al2O3 molar ratio. The optimized conditions were identified as K2S2O7/Al(2)O(3 )as molar ratio 3.55:1, calcining temperature up to 212 degrees C and calcining time of 3.1 h, in which the alumina extraction rate was recorded as 93.28%. The characteristics of CFA and leaching residues were studied by using XRD, SEM and Al-27 and Si-29 MAS-NMR. Results show that K2S2O7 removes the aluminum and effectively breaks the high polymerization units of Si-O-Al and Al-O. The mineral transformation during calcined reaction follows as K2S2O7 + CFA (mullite, corundum, and amorphous phase) -> aluminum tri-potassium sulfate -> leached residues rich in silicate + leached metal ions. The surface chemical reactions controlled the calcining process. The apparent rate constant was found to be 3.12 to 4.18 x 10(-3) min(-1) at the temperature range of 180-220 degrees C, respectively. The apparent activation energy was refereed to be 13.579 kJ/mol. These findings indicate that the potassium pyrosulfate calcination activation method gets a high level of the extracting rate, and is industrially applicable to extract alumina. (C) 2020 Elsevier Ltd. All rights reserved.
引用
收藏
页数:12
相关论文
共 50 条
  • [1] Synergistic extraction of rare earth elements and alumina from coal fly ash by potassium pyrosulfate
    Jingjing Zou
    Yiping Sun
    Chunbin Guo
    Daye Chen
    Yonghong Song
    Yongfeng Wu
    Zhaotianhui Li
    JournalofRareEarths, 2024, 42 (04) : 749 - 758
  • [2] Alumina Extraction from Coal Fly Ash via Low-Temperature Potassium Bisulfate Calcination
    Guo, Chunbin
    Zou, Jingjing
    Ma, Shuhua
    Yang, Jianlin
    Wang, Kehan
    MINERALS, 2019, 9 (10)
  • [3] Extraction of alumina from coal fly ash by calcination with calcium chloride process
    Wang, Y. (yi_wang@tsinghua.edu.cn), 1601, Chinese Society for Environmental Sciences (33):
  • [4] Efficient separation and extraction of alumina from coal fly ash using the potassium pyrosulfate and ammonium sulfate synergistic roasting-leaching process
    Bian, Zhenzhong
    Duan, Zhonghang
    Yang, Zhenyu
    Zhao, Yifan
    Yang, Donghui
    An, Qi
    Liu, Zhicheng
    SEPARATION AND PURIFICATION TECHNOLOGY, 2025, 364
  • [5] Synergistic extraction of rare earth elements and alumina from coal fl y ash by potassium pyrosulfate
    Zou, Jingjing
    Sun, Yiping
    Guo, Chunbin
    Chen, Daye
    Song, Yonghong
    Wu, Yongfeng
    Li, Zhaotianhui
    JOURNAL OF RARE EARTHS, 2024, 42 (04) : 749 - 758
  • [6] Effect of mechanical activation on alumina extraction from coal fly ash
    Gao, Li
    Zhao, Xingjie
    Hu, Tu
    He, Lei
    Lv, Tingting
    CANADIAN METALLURGICAL QUARTERLY, 2025, 64 (01) : 274 - 285
  • [7] Extraction of Alumina from Coal Fly Ash with Sulfuric Acid Leaching Method
    李来时
    吴玉胜
    刘瑛瑛
    翟玉春
    过程工程学报, 2011, 11 (02) : 254 - 258
  • [8] Extraction of alumina from coal fly ash by mixed-alkaline hydrothermal method
    Li, Huiquan
    Hui, Junbo
    Wang, Chenye
    Bao, Weijun
    Sun, Zhenhua
    HYDROMETALLURGY, 2014, 147 : 183 - 187
  • [9] Cleaner extraction of alumina from coal fly ash: Baking-electrolysis method
    Shi, Yuan
    Jiang, Kai-xi
    Zhang, Ting-an
    FUEL, 2020, 273
  • [10] Thermal activation of coal fly ash by sodium hydrogen sulfate for alumina extraction
    Guo, Chunbin
    Zou, Jingjing
    Jiang, Yinshan
    Huang, Tianping
    Cheng, Yan
    Wei, Cundi
    JOURNAL OF MATERIALS SCIENCE, 2014, 49 (12) : 4315 - 4322