Radiological properties of MAGIC normoxic polymer gel dosimetry

For a polymer gel dosimeter to be of use in radiation dosimetry, it should display water-equivalent radiological properties. In this study, the radiological properties of the MAGIC (Methacrylic and Ascorbic acid in Gelatin Initiated by Copper) normoxic polymer gels were investigated. The mass density (rho) was determined based on Archimedes principle. The weight fraction of elemental composition and the effective atomic number (Z(eff)) were calculated. The electron density was also measured with 90 degrees scattering angle at room temperature. The linear attenuation coefficient (mu) of unirradiated gel, irradiated gel, and water were determined using Am-241 based on narrow beam geometry. Monte Carlo simulation was used to calculate the depth doses response of MAGIC gel and water for 6MV photon beam. The weight fractions of elements composition of MAGIC gel were close to that for water. The mass density was found to be 1027 +/- 2 kg m(-3), which is also very close to mass density of muscle tissue (1030 kg m(-3)) and 2.7% higher than that of water. The electron density (rho(e)) and atomic number (Z(eff)) were found to be 3.43 x 10(29) e m(-3) and 7.105, respectively. The electron density measured was 2.6% greater than that for water. The atomic number was very close to that for water. The prepared MAGIC gel was found to be water equivalent based on the study of element composition, mass density, electron density and atomic number. The linear attenuation coefficient of unirradiated gel was very close to that of water. The mu of irradiated gel was found to be linear with dose 2-40 Gy. The depth dose response for MAGIC gel from a 6 MV photon beam had a percentage dose difference to water of less than 1%. Therefore it satisfies the criteria to be a good polymer gel dosimeter for radiotherapy.