Combined effect of smear layer characteristics and hydrostatic pulpal pressure on dentine bond strength of HEMA-free and HEMA-containing adhesives

Objective: This study evaluated the combined effect of smear layer characteristics with hydrostatic pulpal pressure (PP) on bond strength and nanoleakage expression of HEMA-free and -containing self-etch adhesives. Methods: Flat dentine surfaces were obtained from extracted human molars. Smear layers were created by grinding with #180- or #600-SiC paper. Three HEMA-free adhesives (Xeno V, G Bond Plus, Beautibond Multi) and two HEMA-containing adhesives (Bond Force, Tri-S Bond) were applied to the dentine surfaces under hydrostatic PP or none. Dentine bond strengths were determined using the microtensile bond test (mu TBS). Data were statistically analyzed using three-and two-way ANOVA with Tukey post hoc comparison test. Nanoleakage evaluation was carried out under a scanning electron microscope (SEM). Results: Coarse smear layer preparation and hydrostatic PP negatively affected the mu TBS of HEMA-free and -containing adhesives, but there were no significant differences. The combined experimental condition significantly reduced mu TBS of the HEMA-free adhesives, while the HEMA-containing adhesives exhibited no significant differences. Two-way ANOVA indicated that for HEMA-free adhesives, there were significant interactions in mu TBS between smear layer characteristics and pulpal pressure, while for HEMA-containing adhesives, there were no significant interactions between them. Nanoleakage formation within the adhesive layers of both adhesive systems distinctly increased in the combined experimental group. Conclusion: The combined effect of coarse smear layer preparation with hydrostatic PP significantly reduced the mu TBS of HEMA-free adhesives, while in HEMA-containing adhesives, these effects were not obvious. (C) 2013 Elsevier LtdElsevier B.V. All rights reserved.