Lithium-rich manganese oxide spinel thin films as 3 V electrode for lithium batteries

Thin film positive electrodes of lithium-rich manganese oxide spinels were prepared by radiofrequency magnetron sputtering from a LiMn2O4 ceramic target at a total pressure close to 2 Pa. Post-annealing treatments were necessary to get well-crystallized thin films displaying interesting electrochemical performances. Raman spectrum exhibiting several well-defined bands between 296 and 635 cm(-1) is typical for the lithium-rich spinel. Based on ICP, RBS and XRD analyses, the thin films composition is close to Li1.2Mn1.8O4. The latter is also in accordance with a Mn3+/Mn4+ ratio close to 0.1 deduced from XPS measurements. Best electrochemical performance (capacity value, cycling life) between 2V and 3.5V vs Li+/Li was obtained for thin films annealed at 600 degrees C. A volumetric capacity of 52 mu Ah cm(-2) mu m(-1) (close to about 90% of the theoretical value) was obtained at the first cycle at a C/100 regime. Contrary to most studies carried out on spinel thin films cycled in the 3 V range, no appreciable degradation of the discharge capacity was observed after few tens of cycles at room temperature, highlighting the beneficial effect of substituting 20% of Mn ions by Li ions and the presence of microvoids in thin films that limits the effect of strain generated from volume variation during the Li insertion/deinsertion process. (C) 2015 Elsevier Ltd. All rights reserved.