Failure analysis of adhesively-bonded skin-to-stiffener joints: Metal-metal vs. composite-metal

The purpose of this research is to evaluate the performance of two adhesively bonded skin-to-stiffener connections: composite stiffener bonded to a Fiber Metal Laminate (FML) skin, representing a hybrid joint, and an Aluminium stiffener bonded to a FML skin, representative for a metal joint. The bonded joints were tested using Stiffener Pull-Off Tests (SPOT), which is a typical set-up used to simulate the structural behavior of full-scale components subject to out-of-plane loading, such as internal pressure of a fuselage or leading edge low pressure zone. In the hybrid joint, the damage initiates at the central noodle of the composite stiffener. Unstable delamination then propagates from the noodle to the tip of the stiffener foot, preferably through the stiffener foot plies (>90% of inter/intra-laminar failure) and, in limited areas, through the adhesive bond line (<10% of cohesive failure). In the metal joint, the failure starts at the tip of the stiffener foot at the adhesive bond line. Unstable debonding then propagates along the stiffeners foot. The complete failure occurs in the adhesive bond line (100% cohesive failure). The loads associated with >90% of inter/intra laminar failure of the composite stiffener (hybrid joint) are 40-60% lower than the ones associated with 100% cohesive failure (metal joint). This research identifies that in order to use the full capacity of adhesively bonded hybrid joints, the adhesion between carbon fibers of the composite laminate, ie intralaminar strength, must be improved. Otherwise, Aluminium stringers are still very competitive. (C) 2015 Elsevier Ltd. All rights reserved.