High Performance Gear Hobbing with powder-metallurgical High-Speed-Steel

被引：22

作者：

Karpuschewski, Bernhard ^{[1
]}

Knoche, Hans-Joachim ^{[1
]}

Hipke, Martin ^{[1
]}

Beutner, Martin ^{[1
]}

机构：

[1] Univ Magdeburg, Inst Mfg Technol & Qual Management, D-39106 Magdeburg, Germany

来源：

FIFTH CIRP CONFERENCE ON HIGH PERFORMANCE CUTTING 2012 | 2012年 / 1卷

关键词：

Cutting; Gear; Dry Hobbing;

D O I：

10.1016/j.procir.2012.04.034

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

In the module range of 1.5 - 4 mm hobbing is still the most productive process for external gears. The trend for green manufacturing and the increasing cost pressures lead to an increase of dry hobbing. To apply dry hobbing, the cutting speed has to be increased compared to wet cutting. This paper shows that dry hobbing with PM-HSS is feasible and economic. Additionally, a method to determine guide values for dry hobbing will be presented. (C) 2012 The Authors. Published by Elsevier B.V. Selection and/or peer-review under responsibility of Professor Konrad Wegener

引用

页码：196 / 201

页数：6

共 12 条

[1] FEM-supported simulation of chip formation and flow in gear hobbing of spur and helical gears [J].

Bouzakis, K. -D. ;

Friderikos, O. ;

Tsiafis, I. .

CIRP JOURNAL OF MANUFACTURING SCIENCE AND TECHNOLOGY, 2008, 1 (01) :18-26

[2]

Bouzakis K. D., 1980, THESIS TH AACHEN

[3]

Hipke M., 2011, THESIS U MAGDEBURG

[4]

Hoffmeister B., 1970, THESIS TH AACHEN

[5]

JOPPA K, 1977, THESIS TH AACHEN

[6] Gear finishing by abrasive processes [J].

Karpuschewski, B. ;

Knoche, H. -J. ;

Hipke, M. .

CIRP ANNALS-MANUFACTURING TECHNOLOGY, 2008, 57 (02) :621-640

[7]

Klocke F., 2002, FORSCHUNGSVORHABEN A

[8]

Knoche H.-J., 2010, UNVEROFFENTLICHTE UN

[9]

Knoche H.-J., 2005, WIRTSCHAFTLICHES HOC

[10]

MUNDT A, 1992, THESIS RWTH AACHEN

← 1 2 →