Ultra-precision cutting of difficult-to-cut metals

被引：0

作者：

Sakamoto, S ^{[1
]}

Yasui, H ^{[1
]}

Kawada, M ^{[1
]}

Kondo, S ^{[1
]}

机构：

[1] Kumamoto Univ, Dept Mech Engn & Mat Sci, Kumamoto 8608555, Japan

来源：

INITIATIVES OF PRECISION ENGINEERING AT THE BEGINNING OF A MILLENNIUM | 2001年

关键词：

difficult-to-cut metal; stainless steel; ultra-precision cutting; coated cemented carbide bite; cutting fluid;

D O I：

暂无

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

Some attempts on ultra-precision cutting of difficult-to-cut metals with diamond bite are not sufficiently successful because the tool life is too short to produce the ultra-precision components. Special cutting method using high frequency vibration is only reported somewhat available([1]). Then in our previous researches, a coated cemented carbide bite was tried to apply to ultra-precision cutting of titanium alloys. From the result, it is roughly found that the coated bite is available for ultra-precision cutting of the titanium alloys. This research describes on the possibilities of the ultra-precision cutting by the coated bite for stainless steels.

引用

页码：234 / 238

页数：5