Perovskite-type SrFeO3/g-C3N4S-scheme photocatalyst for enhanced degradation of Acid Red B

Semiconductor photocatalysis is extensively used as a feasible solution of water pollution treatment for the removal of hazardous organic pollutants from wastewater. In this research, a perovskite-type SrFeO3/g-C3N4 composite was successfully synthesized by simple calcination method. The properties such as crystal structure, surface chemical composition, micmmorphology and optical properties of the composite materials were characterized by XRD, FT-IR, SEM, EDS, XPS, UV-Vis DRS and PL techniques. The photocatalytic performance of samples was investigated by degrading Acid Red B under UV light irradiation, meanwhile, we optimized the preparation conditions of the binary composites such as the mass ratio of g-C3N4 to SrFeO3, calcination temperature and calcination time, and explored the effect of operating parameters on the efficiency of photocatalytic degradation. The results showed that when the mass ratio of g-C3N4 to SrFeO3 was 3:2, the calcination temperature was 500 degrees C and the calcination time was 3 h, the synthesized SrFeO3/gC(3)N(4) could reach the best photocatalytic activity, which displayed 80.2% degradation efficiency under UV irradiation at 256 nm, the rate was about 3.68, 1.36 and 1.23 times higher than that of pure SrFeO3, g-C3N4 and uncalcined SrFeO3/g-C3N4, respectively. Furthermore, the cyclic tests exhibited satisfactory reusability and stability of SrFeO3/g-C3N4 composite after five cycles, the photocurrent and PL tests proved the high separation efficiency of photogenerated electrons and holes and the high responsivity of the composite, the active species scavenger experiment indicated that center dot O2- played a major role in the photocatalytic reaction. Finally, it was elucidated that the possible mechanism for the enhanced photocatalytic activity of perovskite-type SrFeO3/g-C3N4 photocatalysts.