Effect of interference fit size on local stress in single lap bolted joints

被引：9
作者：
Bi, Yunbo [1 ]
Jiang, Jiefeng [2 ]
Ke, Yinglin [1 ]
机构：
[1] Zhejiang Univ, Dept Mech Engn, Hangzhou 310027, Peoples R China
[2] Hangzhou Normal Univ, Qianjiang Coll, Hangzhou, Zhejiang, Peoples R China
来源：
ADVANCES IN MECHANICAL ENGINEERING | 2015年 / 7卷 / 06期
基金：
中国国家自然科学基金;
关键词：
Interference fit; bolted joint; finite element; strain; maximum principal stress; hoop stress; NUMERICAL INVESTIGATIONS; FATIGUE;
D O I：
10.1177/1687814015590307
中图分类号：
O414.1 [热力学];
学科分类号：
摘要：
The interference fit is an effective process technique to improve the fatigue life of aircraft structures. In this article, the experiments including the interference fit bolt installation and tensile loading in bolted joint were carried out. A three-dimensional finite element model was established to simulate the experimental process, and the finite element model was validated by comparing the simulated data with the experimental data of the squeeze forces and the strains. By finite element simulation and analysis, it can be concluded that the location of maximum value of the maximum principal stress on the upper plate faying surface is going far away from the hole edge with the increase in interference fit size. Furthermore, by analyzing the hoop stress variations along a prescribed path, the maximum value of the hoop tensile stress is smallest at the interference fit size of 1.5%.
引用
收藏
页码：1 / 12
页数：12
相关论文
共 25 条
123