Experimental study and analysis of the purge gas pressure drop across the pebble beds for the fusion HCPB blanket

The lithium ceramic and beryllium pebble beds of the breeder units (BU). in the fusion breeding blanket, are purged by helium to extract the bred tritium. Therefore, the objective of this study is to support the design of the BU purge gas system by studying the effect of pebbles diameter, packing factor, pebble bed length, and flow inlet pressure on the purge gas pressure drop. The pebble bed was formed by packing glass pebbles in a rectangular container (56 mm x 206 mm x 396 mm) and was integrated into a gas loop to be purged by helium at BU-relevant pressures (1.1-3.8 bar). To determine the pressure drop across the pebble bed, the static pressure was measured at four locations along the pebble bed as well as at the inlet and outlet locations. The results show: (i) the pressure drop significantly increases with decreasing the pebbles diameter and slightly increases with increasing the packing factor, (ii) for a constant inlet flow velocity, the pressure drop is directly proportional to the pebble bed length and inlet pressure, and (iii) predictions of Ergun's equation agree well with the experimental values of the pressure drop. (C) 2013 Elsevier B.V. All rights reserved.