Freeze-drying in protective bags: Characterization of heat and mass transfer

During lyophilisation of highly potent Active Pharmaceutical Ingredients (APIs) potential contamination of the freeze-drier is an important safety issue. Since the stoppers are in semistoppered position during the lyophilization process, API may contaminate the chamber and cross-contamination may occur as well. In this study two protective bags, which enclose each tray and their influence on heat and mass transfer during freeze-drying were investigated. Sublimation tests were performed using either purified water or solutions containing trehalose as well as hydroxypropyl-beta-cyclodextrin (HPbCD) as bulking agents. During sublimation tests with purified water both bags clearly influenced heat and mass transfer compared to unpacked reference vials. The bag, which was originally designed to be used for steam sterilization, had a massive impact on drying characteristics. The bag membrane becomes the rate limiting factor, generating a separate compartment within the bag. In this compartment vapor pressure is much higher compared to the chamber pressure during primary drying, leading to altered drying conditions. However, drying was still possible. The other bag, which was specifically designed for lyophilization, also had an impact on drying behavior which could be assigned to the foil between shelf and bottom of the vials. This was detectable as differences in K-v values. Membrane resistance, however, becomes negligible when 10% (w/w) trehalose or HPbCD solutions were dried using the later bag as containment. The data reported in this work demonstrate the relevance and value of sublimation tests to understand the lyophilization process, especially when new components are implemented. The data should be considered, when freeze-drying shall be performed using such bags.