Numerical Investigation on the Effects of Inlet Air Temperature on Spray Combustion in a Wall Jet Can Combustor Using the k- Turbulence Model

被引：9

作者：

Jo, Sangpil ^{[1
]}

Kim, Ho Young ^{[1
]}

Yoon, Sam S. ^{[1
]}

机构：

[1] Korea Univ, Dept Mech Engn, Seoul 136701, South Korea

来源：

NUMERICAL HEAT TRANSFER PART A-APPLICATIONS | 2008年 / 54卷 / 12期

关键词：

D O I：

10.1080/10407780802552179

中图分类号：

O414.1 [热力学];

学科分类号：

摘要：

A three-dimensional numerical study was performed to assess the effects of inlet temperature and equivalence ratio on the spray combustion and subsequent NOx emission in a wall jet can combustor (WJCC) installed with twin-fluid air-assisted fuel atomizers. The RNG k- turbulence model, eddy breakup (EBU) combustion model, and the Zeldovich model of NOx formation were utilized in the numerical study. The WJCC was implemented with a swirling air jet at the fuel nozzle exit and two other air jets, known as primary and dilute jets, at downstream locations. The inlet air temperature and overall equivalence ratio were varied from 373 to 1000K and from 0.3 to 0.6, respectively. Our computational study showed that the inlet air of high temperature induced flow acceleration and sufficient jet penetration, which were desirable for achieving uniform temperature distribution at the combustor outlet but unfavorably yielded increased NOx emission. While the inlet air temperature had no prominent influence on the evaporation rate of the fuel drops in the upstream primary zone, its influence appeared to be prominent further downstream.

引用

页码：1101 / 1120

页数：20

共 50 条

[31] Numerical simulation of heat transfer in rotating smooth square ducts using modified k-ω turbulence model
National Key Laboratory on Aero-Engines, Beijing University of Aeronautics and Astronautics, Beijing 100191, China
Beijing Hangkong Hangtian Daxue Xuebao, 2008, 11 (1284-1287):
[32] Numerical Study on Separated Pipe Flow Using a Modified Low Reynolds Number k-ε Turbulence Model
Xi'an Jiaotong University, Xi'an, 710049, China
Ying Yong Li Xue Xue Bao, 2 (91-95):
[33] Numerical study on high-temperature diluted air combustion for the turbulent jet flame in crossflow using an unsteady flamelet model
Lee, K. W.
Choi, D. H.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2009, 52 (25-26) : 5740 - 5750
[34] NUMERICAL INVESTIGATION OF IGNITION SEQUENCE IN A MULTI-BURNER METHANE-AIR SWIRL COMBUSTOR USING FLAMELET GENERATED MANIFOLD COMBUSTION MODEL
Nakod, Pravin
Shrivastava, Sourabh
Patwardhan, Saurabh
Orsino, Stefano
Yadav, Rakesh
PROCEEDINGS OF THE ASME TURBO EXPO: TURBOMACHINERY TECHNICAL CONFERENCE AND EXPOSITION, 2019, VOL 4A, 2019,
[35] Numerical investigation of the fully developed turbulent flow over a moving wavy wall using k-epsilon turbulence model
Hafez, K. A.
Elsamni, O. A.
Zakaria, K. Y.
ALEXANDRIA ENGINEERING JOURNAL, 2011, 50 (02) : 145 - 162
[36] CFD INVESTIGATION OF FLOW OVER A BACKWARD-FACING STEP USING AN RNG k-ε TURBULENCE MODEL
Darmawan, Steven
Tanujaya, Harto
INTERNATIONAL JOURNAL OF TECHNOLOGY, 2019, 10 (02) : 280 - 289
[37] Investigation of the Trailing Edge Modification Effect on Compressor Blade Aerodynamics Using SST k- Turbulence Model
Kaewbumrung, Mongkol
Tangsopa, Worapol
Thongsri, Jatuporn
AEROSPACE, 2019, 6 (04):
[38] Effects of combustor wall temperature on the outer recirculation zone combustion modes transition in lean premixed DME/air swirling flames
Lin, Wenjun
Zhang, Weijie
An, Zhenhua
Wang, Jinhua
Huang, Zuohua
Zhang, Huangwei
FUEL, 2025, 381
[39] Analytical and numerical solutions of the problem of gravity-induced mixing of a light layer using the k-ε turbulence model
Sin'kova, O. G.
Statsenko, V. P.
Yanilkin, Yu. V.
FLUID DYNAMICS, 2016, 51 (06) : 745 - 756
[40] Experimental investigation of ethylene/air combustion instability in a model scramjet combustor using image-based methods
Nakaya, Shinji
Yamana, Hajime
Tsue, Mitsuhiro
PROCEEDINGS OF THE COMBUSTION INSTITUTE, 2021, 38 (03) : 3869 - 3880

← 1 2 3 4 5 →