Degree of imidization for polyimide films investigated by evolved gas analysis-mass spectrometry

被引:17
作者
Kim, Byoung-Hyoun [1 ]
Park, Huijung [1 ]
Park, Heeyong [1 ]
Moon, Dong Cheul [2 ]
机构
[1] LG Chem Ltd, Analyt Sci, LG Chem, Taejon 305380, South Korea
[2] Chungbuk Natl Univ, Coll Pharm, Cheongju 361763, South Korea
关键词
Degree of imidization; Polyimide; Evolved gas analysis-mass spectrometry; THERMAL IMIDIZATION; THIN-FILMS; STRUCTURAL EVOLUTION; POLYAMIC ACID; CU; NANOPARTICLES; BEHAVIOR;
D O I
10.1016/j.tca.2012.10.029
中图分类号
O414.1 [热力学];
学科分类号
摘要
The evolved gas analysis-mass spectrometry (EGA-MS) method is described as a new approach for determining the degree of imidization (DOI) in polyimide (PI) films. Partially imidized PI films allowed water to release through the re-imidization process at a sufficiently high imidization temperature. Evolved water from the re-imidization process was quantitatively detected by EGA-MS. From the obtained water content, the number of moles of residual amic acid groups in repeating units of PI was found. Consequently, the DOI of the PI films could be found from the mole ratio of PI and the sum of the PI and the residual polyamic acid (PAA). A water content of 0.018% and a DOI of 99.85% can be measured from 40 mg of PI films using this method. In this study, it was found that rigid PIs showed fast imidization reactions at relatively lower temperatures, while flexible PIs were activated and showed fast imidization reactions at relatively higher temperatures. In addition, the end point of the imidization process in multi-layer PI films was determined by this method. (C) 2012 Elsevier B.V. All rights reserved.
引用
收藏
页码:184 / 190
页数:7
相关论文
共 18 条
  • [1] Site-selective direct silver metallization on surface-modified polyimide layers
    Akamatsu, K
    Ikeda, S
    Nawafune, H
    [J]. LANGMUIR, 2003, 19 (24) : 10366 - 10371
  • [2] Formation of Cu-based nanoparticles during imidization of PAA into PI in the various environments
    Choi, Jae-Youn
    Dong, Wenguo
    Kim, Young-Ho
    [J]. COLLOIDS AND SURFACES A-PHYSICOCHEMICAL AND ENGINEERING ASPECTS, 2008, 313 : 335 - 338
  • [3] Thermal imidization optimization of polyimide thin films using Fourier transform infrared spectroscopy and electrical measurements
    Diaham, S.
    Locatelli, M. L.
    Lebey, T.
    Malec, D.
    [J]. THIN SOLID FILMS, 2011, 519 (06) : 1851 - 1856
  • [4] A study of the curing behavior of polyamic acid coated on a Cu or Zn layer
    Dong, Wen-Guo
    Kim, Gun-Hong
    Choi, Jae-Youn
    Ybon, Jun-Ro
    Kim, Young-Ho
    [J]. COLLOIDS AND SURFACES A-PHYSICOCHEMICAL AND ENGINEERING ASPECTS, 2008, 324 (1-3) : 122 - 125
  • [5] Spontaneous molecular orientation of polyimides induced by thermal imidization .2. In-plane orientation
    Hasegawa, M
    Matano, T
    Shindo, Y
    Sugimura, T
    [J]. MACROMOLECULES, 1996, 29 (24) : 7897 - 7909
  • [6] Influence of curing temperature on the optical properties of fluorinated polyimide thin films
    Jin, Xi
    Zhu, Daqing
    [J]. EUROPEAN POLYMER JOURNAL, 2008, 44 (11) : 3571 - 3577
  • [7] Fabrication and structural analysis of aromatic polyimide ultra-thin films with different fluorine contents
    Kang, Yun Ji
    Kim, Hwajeong
    Kim, Eunju
    Kim, Il
    Ha, Chang-Sik
    [J]. COLLOIDS AND SURFACES A-PHYSICOCHEMICAL AND ENGINEERING ASPECTS, 2008, 313 : 585 - 589
  • [8] Synthesis of duplex nanoparticles in polyimide by the reaction of polyamic acid with Cu-Zn alloy films
    Kim, Gun-Hong
    Dong, Wenguo
    Yoon, Chong Seung
    Kim, Young-Ho
    [J]. COLLOIDS AND SURFACES A-PHYSICOCHEMICAL AND ENGINEERING ASPECTS, 2008, 321 (1-3) : 292 - 296
  • [9] Effect of poly(amic acid) imidization on solution characteristics and membrane morphology
    Lee, HJ
    Won, J
    Park, HC
    Lee, H
    Kang, YS
    [J]. JOURNAL OF MEMBRANE SCIENCE, 2000, 178 (1-2) : 35 - 41
  • [10] Effects of post-thermal treatment on preparation of surface microstructures induced by polarized laser on polyimide film
    Li, M
    Lu, QH
    Yin, J
    Qian, Y
    Wang, ZG
    [J]. MATERIALS CHEMISTRY AND PHYSICS, 2003, 77 (03) : 895 - 898