Intermetallic phase evolution and strengthening effect in Al-Mg2Si alloys with different Cu/Ni ratios

被引：30

作者：

Sun, Yilin ^{[1
]}

Li, Chong ^{[1
]}

Liu, Yongchang ^{[1
]}

Yu, Liming ^{[1
]}

Li, Huijun ^{[2
]}

机构：

[1] Tianjin Univ, Sch Mat Sci & Engn, State Key Lab Hydraul Engn Simulat & Safety, Tianjin 300350, Peoples R China

[2] Univ Wollongong, Sch Mech Mat & Mechatron Engn, Wollongong, NSW 2522, Australia

来源：

MATERIALS LETTERS | 2018年 / 215卷

基金：

中国国家自然科学基金;

关键词：

Metals and alloys; Casting; Intermetallic phases; Microstructure; Mechanical properties; IN-SITU; MECHANICAL-PROPERTIES; MICROSTRUCTURAL EVOLUTION; HYPEREUTECTIC AL-MG2SI; NANOCRYSTALLINE MG2SI; TENSILE PROPERTIES; NI; CU; BEHAVIOR; HARDNESS;

D O I：

10.1016/j.matlet.2017.12.067

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

Microalloying of an Al-15%Mg2Si alloy (wt%) with Ni and Cu produced an enhanced strengthening response, increasing hardness whilst also improving tensile strength due to the formation and evolution of intermetallic phases. With the increase of Cu/Ni ratios, intermetallic phases translate from Al3Ni or Al3CuNi to Al7Cu4Ni, and the total volume fraction of Al3CuNi and Al7Cu4Ni increases to 3.51% (1% Ni and 5% Cu, Cu/Ni ratio = 5). The thermally stable Al3CuNi and Al7Cu4Ni phases are connected to each other forming chains and tend to build up a network. As a result, the ultimate tensile strength (at 350 degrees C) of the alloy (Cu/Ni ratio = 5) reached up to 132 MPa, 131.6% higher than that of Al-15%Mg2Si alloy. (C) 2017 Elsevier B.V. All rights reserved.

引用

页码：254 / 258

页数：5

共 50 条

[41] Influences of Cu Content on the Microstructure and Strengthening Mechanisms of Al-Mg-Si-xCu Alloys [J].

Chen, Yuqiang ;

Hu, Qiang ;

Pan, Suping ;

Zhang, Hao ;

Liu, Huiqun ;

Zhu, Biwu ;

Liu, Xiao ;

Liu, Wenhui .

METALS, 2019, 9 (05)

[42] Influence of Gd content on microstructure and mechanical properties of cast Al-12Si-4Cu-2Ni-0.8Mg alloys [J].

Sui, Yudong ;

Wang, Qudong ;

Liu, Teng ;

Ye, Bing ;

Jiang, Haiyan ;

Ding, Wenjiang .

JOURNAL OF ALLOYS AND COMPOUNDS, 2015, 644 :228-235

[43] Effect of Minor Addition of Ni and Zr on the High-Temperature Performance of Al-Si-Cu-Mg Cast Alloys [J].

Hernandez-Sandoval, J. ;

Zedan, Y. ;

Songmene, V ;

Abdelaziz, M. H. ;

Samuel, F. H. ;

Garza-Elizondo, G. H. .

INTERNATIONAL JOURNAL OF METALCASTING, 2022, 16 (03) :1235-1251

[44] Effect of magnesium on dispersoid strengthening of Al-Mn-Mg-Si (3xxx) alloys [J].

Li, Zhen ;

Zhang, Zhan ;

Chen, X-Grant .

TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA, 2016, 26 (11) :2793-2799

[45] Crystallographic characterization of Al18Mg3Ti2 intermetallic phase in Al-Zn-Mg-Cu-Zr-Ti alloy [J].

Lee, Sang-Hwa ;

Kayani, Saif Haider ;

Jung, Jae-Gil ;

Baik, Sung-Il ;

Kim, Min-Seok ;

Lee, Young-Kook ;

Euh, Kwangjun .

JOURNAL OF ALLOYS AND COMPOUNDS, 2020, 844

[46] Influence of the Precipitation of Secondary Phase on the Thermal Diffusivity Change of Al-Mg2Si Alloys [J].

Kim, Yu-Mi ;

Choi, Se-Weon ;

Kim, Young-Chan ;

Kang, Chang-Seok ;

Hong, Sung-Kil .

APPLIED SCIENCES-BASEL, 2018, 8 (11)

[47] Effect of reinforcement amount, mold temperature, superheat, and mold thickness on fluidity of in-situ Al-Mg2Si composites [J].

Barenji, Reza Vatankhah .

CHINA FOUNDRY, 2018, 15 (01) :66-74

[48] Phase formation in as-solidified and heat-treated Al-Si-Cu-Mg-Ni alloys: Thermodynamic assessment and experimental investigation for alloy design [J].

Farkoosh, A. R. ;

Javidani, M. ;

Hoseini, M. ;

Larouche, D. ;

Pekguleryuz, M. .

JOURNAL OF ALLOYS AND COMPOUNDS, 2013, 551 :596-606

[49] The natural aging and precipitation hardening behaviour of Al-Mg-Si-Cu alloys with different Mg/Si ratios and Cu additions [J].

Ding, Lipeng ;

Jia, Zhihong ;

Zhang, Zhiqing ;

Sanders, Robert E. ;

Liu, Qing ;

Yang, Guang .

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2015, 627 :119-126

[50] Effect of Mg level on the microstructure and mechanical properties of die-cast Al-Si-Cu alloys [J].

Yang, Hailin ;

Ji, Shouxun ;

Yang, Wenchao ;

Wang, Yun ;

Fan, Zhongyun .

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2015, 642 :340-350

← 1 2 3 4 5 →