Optical and thermal analysis of a parabolic trough solar collector for production Of thermal energy in different climates in Iran with comparison between the conventional nanofluids

被引:138
作者
Marefati, Mohammad [1 ]
Mehrpooya, Mehdi [2 ,3 ]
Shafii, Mohammad Behshad [4 ]
机构
[1] Islamic Azad Univ, Sci & Res Branch, Dept Energy, Tehran, Iran
[2] Univ Tehran, Fac New Sci & Technol, Renewable Energies & Environm Dept, Tehran, Iran
[3] Univ Tehran, Fac New Sci & Technol, Hydrogen & Fuel Cell Lab, Tehran, Iran
[4] Sharif Univ, Dept Mech Engn, Tehran, Iran
关键词
Parabolic trough collector; Thermal performance; Numerical modelling; Nanofluid; EXERGY ANALYSIS; DISH COLLECTOR; CYCLE DRIVEN; POWER CYCLE; PERFORMANCE; OPTIMIZATION; DESIGN; SYSTEM; CONSTRUCTION; ENHANCEMENT;
D O I
10.1016/j.jclepro.2017.12.080
中图分类号
X [环境科学、安全科学];
学科分类号
08 ; 0830 ;
摘要
Optical and thermal analysis of the most well-known solar concentrator system; parabolic trough collector (PTC) are investigated and analyzed. To evaluate performance of the PTC, four cities of Iran with different weather conditions are chosen as case studies. Effective parameters such as concentration ratio, incident angle correction factor, collector mass flow rate are considered. The main objective of this work is evaluation of the solar energy potential using PTC in under consideration cities with different climates. Numerical modeling of the analysis is don,e using MATLAB software. Simulation results shows that Shiraz, with an average annual thermal efficiency of 13.91% and annual useful energy of 2213 kWh/m(2), is the best region to use solar concentrator systems. The impacts of other parameters such as fluid inlet temperature, input fluid flow rate and aperture area of the collector on the output of the system are also investigated. Finally, the effect of using nanofluids as heat transfer fluid on increasing the heat transfer is investigated. (C) 2017 Elsevier Ltd. All rights reserved.
引用
收藏
页码:294 / 313
页数:20
相关论文
共 44 条
[1]   Exergoeconomic analysis and multi objective optimization of performance of a Carbon dioxide power cycle driven by geothermal energy with liquefied natural gas as its heat sink [J].
Ahmadi, Mohammad H. ;
Mehrpooya, Mehdi ;
Pourfayaz, Fathollah .
ENERGY CONVERSION AND MANAGEMENT, 2016, 119 :422-434
[2]   Thermo-economic modeling and optimization of an irreversible solar-driven heat engine [J].
Ahmadi, Mohammad Hossein ;
Mehrpooya, Mehdi .
ENERGY CONVERSION AND MANAGEMENT, 2015, 103 :616-622
[3]   Comparative study to use nano-(Al2O3, CuO, and SiC) with water to enhance photovoltaic thermal PV/T collectors [J].
Ai-Waeli, Ali H. A. ;
Chaichan, Miqdam T. ;
Kazem, Hussein A. ;
Sopian, K. .
ENERGY CONVERSION AND MANAGEMENT, 2017, 148 :963-973
[4]  
Alfellag M.A.A., 2014, Modeling and experimental investigation of parabolic trough solar collector
[5]  
[Anonymous], 2013, SOLAR ENERGY ENG PRO, DOI DOI 10.1016/B978-0-12-374501-9.00014-5
[6]   Techno-economic assessment of a Kalina cycle driven by a parabolic Trough solar collector [J].
Ashouri, Milad ;
Vandani, Amin Mohammadi Khoshkar ;
Mehrpooya, Mehdi ;
Ahmadi, Mohammad H. ;
Abdollahpour, Amir .
ENERGY CONVERSION AND MANAGEMENT, 2015, 105 :1328-1339
[7]   Optical and thermal evaluations of a medium temperature parabolic trough solar collector used in a cooling installation [J].
Balghouthi, Moncef ;
Ali, Abdessalem Bel Hadj ;
Trabelsi, Seif Eddine ;
Guizani, Amenallah .
ENERGY CONVERSION AND MANAGEMENT, 2014, 86 :1134-1146
[8]   Thermal enhancement of solar parabolic trough collectors by using nanofluids and converging-diverging absorber tube [J].
Bellos, E. ;
Tzivanidis, C. ;
Antonopoulos, K. A. ;
Gkinis, G. .
RENEWABLE ENERGY, 2016, 94 :213-222
[9]   Geometric analysis of three-dimensional effects of parabolic trough collectors [J].
Binotti, Marco ;
Zhu, Guangdong ;
Gray, Allison ;
Manzolini, Giampaolo ;
Silva, Paolo .
SOLAR ENERGY, 2013, 88 :88-96
[10]   Parabolic trough solar thermal power plant: Potential, and projects development in Algeria [J].
Boukelia, Taqiy Eddine ;
Mecibah, Mohamed-Salah .
RENEWABLE & SUSTAINABLE ENERGY REVIEWS, 2013, 21 :288-297