Effects of Sintering Temperature on the Response of CuFeTe2 Ceramics to Oxygen Gas

被引：0
|
作者：
Kozaki, Masatoshi [1 ]
Tokunaga, Yuta [1 ]
Huang, Yezhi [1 ]
Kuriyaki, Hisao [1 ]
Toko, Kiyoshi [1 ]
机构：
[1] Kyushu Univ, Grad Sch Informat Elect Engn, Nishi Ku, 744 Motooka, Fukuoka 8190395, Japan
来源：
SENSORS AND MATERIALS | 2016年 / 28卷 / 03期
关键词：
oxygen gas sensor; intercalation; layered material; COMPOUND CUFETE2; THIN-FILMS;
D O I：
暂无
中图分类号：
TH7 [仪器、仪表];
学科分类号：
0804 ; 080401 ; 081102 ;
摘要：
A new oxygen sensor based on the resistance change caused by oxygen intercalation in the layered compound CuFeTe2 (CFT) was developed. When intercalation occurs, oxygen molecules penetrate into the CFT interlayer, stretching the van der Waals gap and increasing the c -axis resistance. In this study, we prepared ceramic samples from a single crystal using different sintering temperatures. Results show that the sample sintered at 100 degrees C showed the highest oxygen gas response. Moreover we carried out the surface observation of the cross section of each CFT ceramic sample and found that the porosity of the sample increased with decreasing sintering temperature.
引用
收藏
页码：231 / 236
页数：6
相关论文
共 45 条
  • [41] Radio frequency sputter deposition of Cu2ZnSnS4 thin films with a temperature-controlled reflector wall: Effects of H2 addition to the sputtering gas
    Kusano, Eiji
    Kondo, Yu
    THIN SOLID FILMS, 2018, 646 : 75 - 82
  • [42] Ultra-sensitive and selective acetone gas sensor with fast response at low temperature based on Cu-doped α-Fe2O3 porous nanotubes
    Cheng, Yali
    He, Yue
    Li, Shuo
    Wang, Yifang
    Zhao, Yan
    Li, Yu
    Li, Haiying
    Liu, Li
    JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS, 2018, 29 (13) : 11178 - 11186
  • [43] Output evaluation of resistive oxygen sensor having Ce0.9Zr0.1O2 sensing material and Zr0.8Y0.2O2-δ temperature compensating material in model exhaust gas
    Izu, Noriya
    Nishizaki, Sayaka
    Itoh, Toshio
    Shin, Woosuck
    Matsubara, Ichiro
    Murayama, Norimitsu
    JOURNAL OF THE CERAMIC SOCIETY OF JAPAN, 2007, 115 (1347) : 688 - 691
  • [44] Enhanced gas sensing response for 2D α-MoO3 layers: Thickness-dependent changes in defect concentration, surface oxygen adsorption, and metal-metal oxide contact
    Bisht, Prashant
    Kumar, Arvind
    Jensen, Ingvild Thue
    Ahmad, Mujeeb
    Belle, Branson D.
    Mehta, B. R.
    SENSORS AND ACTUATORS B-CHEMICAL, 2021, 341
  • [45] Effects of IGZO film thickness on H2S gas sensing performance: Response, excessive recovery, low-frequency noise, and signal-to-noise ratio
    Shin, Wonjun
    Kwon, Daehee
    Ryu, Minjeong
    Kwon, Joowon
    Hong, Seongbin
    Jeong, Yujeong
    Jung, Gyuweon
    Park, Jinwoo
    Kim, Donghee
    Lee, Jong-Ho
    SENSORS AND ACTUATORS B-CHEMICAL, 2021, 344
12345