共 39 条
Biodiesel production via simultaneous esterification and transesterification of chicken fat oil by mesoporous sulfated Ce supported activated carbon
被引:55
作者:
Shobhana-Gnanaserkhar
[1
,2
,3
]
Asikin-Mijan, N.
[4
]
AbdulKareem-Alsultan, G.
[5
]
Sivasangar-Seenivasagam
[6
]
Izham, Saiman Mohd
[1
,2
,3
]
Taufiq-Yap, Y. H.
[1
,2
,7
]
机构:
[1] Univ Putra Malaysia, Catalysis Sci & Technol Res Ctr PutraCat, Upm Serdang 43400, Selangor, Malaysia
[2] Univ Putra Malaysia, Fac Sci, Upm Serdang 43400, Selangor, Malaysia
[3] Univ Putra Malaysia, Fac Sci, Dept Chem, Upm Serdang 43400, Selangor, Malaysia
[4] Univ Kebangsaan Malaysia, Fac Sci & Technol, Ukm Bangi 43600, Selangor Darul, Malaysia
[5] Univ Putra Malaysia, Fac Engn, Chem & Environm Engn Dept, Upm Serdang 43400, Selangor, Malaysia
[6] Univ Putra Malaysia, Dept Chem, Bintulu Campus, Sarawak 97008, Malaysia
[7] Univ Malaysia Sabah, Chancellery Off, Kota Kinabalu 88400, Sabah, Malaysia
关键词:
Biodiesel;
Esterification;
Transesterification;
Chicken fat oil;
Cerium;
SOLID ACID CATALYST;
WASTE COOKING OIL;
PALM OIL;
OLEIC-ACID;
HETEROGENEOUS CATALYST;
CO2;
HYDROGENATION;
OXIDE CATALYST;
SOYBEAN OIL;
OPTIMIZATION;
DISTILLATE;
D O I:
10.1016/j.biombioe.2020.105714
中图分类号:
S2 [农业工程];
学科分类号:
0828 ;
摘要:
Biodiesel, as an alternative fuel for petroleum-derived fuel, has gained significant attention from society. In this research work, biodiesel is produced via simultaneous esterification and transesterification of chicken fat and skin oil (CFSO) over Ce supported sulfated activated carbon derived from coconut shell (AC(cs)-S). Details of a study on the effect of Ce concentrations in the range of 5-15 wt% were also investigated. The results showed that 5 wt% Ce was an optimum concentration for the esterification and transesterification of CFSO with approximately 93% free fatty acid (FFA) conversion. High FFA conversion by 5Ce/ACcs-S is attributed to it having a sufficient amount of acid-base and noticeable pore structures. The effect of four variables (i.e., methanol to chicken fat oil, catalyst loading, reaction time, and temperature) on the FFA conversion was studied via the one-variable-at-a-time method. Optimum FFA conversion (93%) was achieved at a temperature of 90 degrees C, 12:1 MeOH to oil ratio, 3 wt % catalyst loading, and 1 h reaction time. 5Ce/AC(cs)-S shows high chemical stability by maintaining the FFA conversion at up to 90% within five consecutive reaction cycles.
引用
收藏
页数:13
相关论文