MgTi2O5 thin films from single molecular precursor for photoelectrochemical water splitting

Magnesium dititanate MgTi2O5, thin films have been grown on fluorine doped tin oxide (FTO) substrates using a newly synthesized heterobimetallic single molecular precursor [Mg2Ti4(O)(2)(OH)(4)(TFA)s(THF)(6)]center dot THF (1) (where TFA=trifluroacetato and THF=tetrahydrofuran) using the aerosol assisted chemical vapor deposition technique (AACVD). The precursor complex (1), isolated in crystalline form by reacting magnesium (II) acetate tertahydrate with titanium (IV) isopropoxide and trifluroacetic acid in THF solution, was characterized byt. FTIR, single-crystal X-ray diffraction and thermogravimetric analyses. Thin films prepared at 500, 550 and 600 degrees C were inspected by X-ray diffraction (XRD), field emission gun-scanning electron microscopic (FESEM), and energy dispersive X-ray spectroscopy (EDX) and X-ray photoelectron spectroscopy (XPS), which demonstrated the development of phase pure orthorhombic porous microspherical objects of MgTi2O5 with precise stoichiometry. The optical analysis showed that MgTi2O5 has a direct band gap of 3.4 eV. The photoelectrochemical (PEC) experiments on MgTi2O5 electrodes showed maximum anodic photocurrent density of 400 pA/cm(2) at 0.7 V vs. Ag/AgCl/3 M KCl under simulated solar irradiation of AM 1.5G (100 mW/cm2) in 1 M NaOH. The improved PEC performance of MgTi2O5 electrode was attributed to the increased photo absorption ability, elevated surface area, and more efficient electron/hole transfer which were confirmed by measurements such as linear sweep voltage, transient photocurrent and electrochemical impedance spectroscopy.