Thermal stratification in an internal combustion engine due to wall heat transfer measured by laser-induced fluorescence

被引:50
|
作者
Kaiser, S. A. [1 ]
Schild, M. [1 ]
Schulz, C. [1 ]
机构
[1] Univ Duisburg Essen, Inst Combust & Gas Dynam, IVG, D-47048 Duisburg, Germany
关键词
HCCI; Tracer LIF thermometry; Heat transfer; Fluorescence; Optical engine; PARTIAL FUEL STRATIFICATION; BOOSTED HCCI; TEMPERATURE; TOLUENE; IGNITION; ACETONE; TRACER; RATES;
D O I
10.1016/j.proci.2012.05.059
中图分类号
O414.1 [热力学];
学科分类号
摘要
Laser-induced fluorescence of toluene was used to image spatial fluctuations of gas temperature in an optically accessible engine. These thermal inhomogeneities develop due to wall heat-transfer and convection during the compression stroke. They are known to be important for slowing heat release when operating the engine in compression auto-ignition (CAI) mode. The engine had a pent-roof four-valve head typical for automotive spark-ignited engines and a flat-top piston with a window. Measurements were performed in the central vertical symmetry plane of the cylinder with the engine motored and fed with nitrogen. Toluene was seeded homogeneously into the intake gas. Fluorescence was excited at 248 nm and detected spectrally integrated. Toluene fluorescence decreases strongly with increasing temperature. Estimating the absolute in-cylinder temperature from isentropic compression along the measured pressure trace, we found the magnitude of this decrease in the engine to be consistent with literature data from heated flow-cell measurements. This calibration allowed for determination of the spatial fluctuations in temperature against the multi-cycle average temperature. Precision error, mostly from laser mode fluctuations, was between 1.6 and 4.0 K depending on crank angle. The results show that the temperature-fluctuation field transitions during the compression stroke from small, evenly distributed inhomogeneities to much greater fluctuations, mostly localized near walls, but convecting into the cylinder center very late in the stroke. There are subtle differences in the spatial structure of the near-wall fluctuation field between cylinder head and piston top. Compiled from the entire imaged area, at top dead-center the standard deviation of the fluctuations was 1.9% of the temperature differential between gas phase and wall, consistent with corresponding literature data. (C) 2012 The Combustion Institute. Published by Elsevier Inc. All rights reserved.
引用
收藏
页码:2911 / 2919
页数:9
相关论文
共 50 条
  • [31] Quantitative detection of hydrogen peroxide in an HCCI engine using photofragmentation laser-induced fluorescence
    Li, B.
    Jonsson, M.
    Algotsson, M.
    Bood, J.
    Li, Z. S.
    Johansson, O.
    Alden, M.
    Tuner, M.
    Johansson, B.
    PROCEEDINGS OF THE COMBUSTION INSTITUTE, 2013, 34 : 3573 - 3581
  • [32] Heat transfer analysis of fast response sensor for internal combustion engine based on Coiflet wavelet finite element method
    Zhao, Bin
    Han, Shuai
    Shi, Cheng Jiang
    Yang, Xue Feng
    Xu, Li Zhi
    Gao, Dian Kui
    Zhang, Yuan Yuan
    JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY, 2017, 129 (02) : 1181 - 1187
  • [33] Heat Release Rate and Flame Thickness of n-butane/Air Jet Flame Measured by Planar Laser-Induced Fluorescence Technology
    Jin Chuan
    Jiang Liqiao
    Li Fan
    Li Xing
    Wang Xiaohan
    CHINESE JOURNAL OF LASERS-ZHONGGUO JIGUANG, 2022, 49 (13):
  • [34] INVESTIGATIONS ON A SPARK-IGNITED ENGINE USING 2-DIMENSIONAL LASER-INDUCED FLUORESCENCE
    BAUERLE, B
    HOFFMANN, F
    BEHRENDT, F
    WARNATZ, J
    BERICHTE DER BUNSEN-GESELLSCHAFT-PHYSICAL CHEMISTRY CHEMICAL PHYSICS, 1993, 97 (12): : 1710 - 1713
  • [35] Simultaneous Laser-Induced Fluorescence Imaging of Unburnt and Reacting Areas in Combustion Fields Using a KrF Excimer Laser
    Masayuki Tamura
    Teruhiro Sakurai
    Hideo Tai
    Optical Review, 1998, 5 : 119 - 123
  • [36] Heat transfer and entropy generation due to a nanofluid over stretching cylinder: Effects of thermal stratification
    Ahmed S.E.
    Mohamed S.S.
    Mansour M.A.
    Mahdy A.
    Ahmed, Sameh E. (sameh_sci_math@yahoo.com), 1600, Begell House Inc. (09): : 29 - 47
  • [37] Numerical heat transfer and thermal engineering of AdBlue (SCR) tanks for combustion engine emission reduction
    der Wiesche, Stefan aus
    APPLIED THERMAL ENGINEERING, 2007, 27 (11-12) : 1790 - 1798
  • [38] Application of planar laser-induced fluorescence measurement techniques to study the heat transfer characteristics of parallel-plate heat exchangers in thermoacoustic devices
    Shi, Lei
    Mao, Xiaoan
    Jaworski, Artur J.
    MEASUREMENT SCIENCE AND TECHNOLOGY, 2010, 21 (11)
  • [39] Combustion structure of free and wall-impinging diesel jets by simultaneous laser-induced fluorescence of formaldehyde, poly-aromatic hydrocarbons, and hydroxides
    Bruneaux, G.
    INTERNATIONAL JOURNAL OF ENGINE RESEARCH, 2008, 9 (03) : 249 - 265
  • [40] A model of laser-induced damage of KDP based on the coupling of statistics and heat transfer
    Duchateau, Guillaume
    Dyan, Anthony
    LASER-INDUCED DAMAGE IN OPTICAL MATERIALS: 2007, 2008, 6720