The effect of simultaneous deformation and annealing on the precipitation behaviour and mechanical properties of an Al-Mg-Si alloy

被引：32

作者：

Teichmann, Katharina ^{[1
]}

Marioara, Calin D. ^{[2
]}

Pedersen, Ketill O. ^{[2
]}

Marthinsen, Knut ^{[1
]}

机构：

[1] Norwegian Univ Sci & Technol, N-7491 Trondheim, Norway

[2] SINTEF Mat & Chem, N-7465 Trondheim, Norway

来源：

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING | 2013年 / 565卷

关键词：

Electron microscopy; Mechanical characterization; Aluminium alloys; Thermomechanical processing; Age hardening; Precipitation; CRYSTAL-STRUCTURE; BETA'-PHASE; MICROSTRUCTURE; SEQUENCE; MODEL;

D O I：

10.1016/j.msea.2012.12.042

中图分类号：

TB3 [工程材料学];

学科分类号：

0805 ; 080502 ;

摘要：

The influence of simultaneous deformation and annealing on the precipitation behaviour and the mechanical properties of an AA6060 Al-Mg-Si alloy were investigated by Transmission Electron Microscopy (TEM) and tensile testing. The results were compared to similar heat-treatments of the un-deformed material and of a material which was pre-deformed 10% before a subsequent annealing. The deformations applied in the present work were simultaneous by 0.6% within 10 min of heat treatment at 190 degrees C, and by 10% within 100 min and 300 min at 190 degrees C. The results show that the precipitation kinetics, microstructure and the tensile strength are greatly dependent on the specific deformation mode applied. When deformation and annealing of the material are simultaneous, precipitation takes place at dislocations which are moving through the material. These precipitates are of post-beta ''-type. Compared to the pre-deformed material, the strength addition by the precipitates is larger in the simultaneous deformation mode due to a finer precipitate distribution, while the strength addition by dislocations appears to be lower. The total yield strength of all peak hardness conditions is similar, due to a compensation of different strength contributions with the highest contribution by precipitates in the un-deformed material. (C) 2012 Elsevier B.V. All rights reserved.

引用

页码：228 / 235

页数：8

共 25 条

[1] The structural relation between precipitates in Al-Mg-Si alloys, the Al-matrix and diamond silicon, with emphasis on the trigonal phase U1-MgAl2Si2 [J].

Andersen, S. J. ;

Marioara, C. D. ;

Vissers, R. ;

Froseth, A. ;

Zandbergen, H. W. .

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2007, 444 (1-2) :157-169

[2] THE DUAL NATURE OF PRECIPITATES IN AL-MG-SI ALLOYS [J].

Andersen, Sigmund J. ;

Marioara, Calin D. ;

Vissers, Rene ;

Torsaeter, Malin ;

Bjorge, Ruben ;

Ehlers, Flemming J. H. ;

Holmestad, Randi .

THERMEC 2009, PTS 1-4, 2010, 638-642 :390-+

[3] Crystal structure of the orthorhombic U2-Al4Mg4Si4 precipitate in the Al-Mg-Si alloy system and its relation to the β′ and β" phases [J].

Andersen, SJ ;

Marioara, CD ;

Froseth, A ;

Vissers, R ;

Zandbergen, HW .

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2005, 390 (1-2) :127-138

[4] The crystal structure of the β" phase in Al-Mg-Si alloys [J].

Andersen, SJ ;

Zandbergen, HW ;

Jansen, J ;

Traeholt, C ;

Tundal, U ;

Reiso, O .

ACTA MATERIALIA, 1998, 46 (09) :3283-3298

[5] The influence of precipitation on the work-hardening behavior of the aluminum alloys AA6111 and AA7030 [J].

Cheng, LM ;

Poole, WJ ;

Embury, JD ;

Lloyd, DJ .

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2003, 34A (11) :2473-2481

[6] Influence of predeformation on ageing in an Al-Zn-Mg alloy -: I.: Microstructure evolution and mechanical properties [J].

Deschamps, A ;

Livet, F ;

Bréchet, Y .

ACTA MATERIALIA, 1998, 47 (01) :281-292

[7] The precipitation sequence in Al-Mg-Si alloys [J].

Edwards, GA ;

Stiller, K ;

Dunlop, GL ;

Couper, MJ .

ACTA MATERIALIA, 1998, 46 (11) :3893-3904

[8] On the coupling between precipitation and plastic deformation in relation with friction stir welding of AA2024 T3 aluminium alloy [J].

Genevois, Cecile ;

Fabregue, Damien ;

Deschamps, Alexis ;

Poole, Waffen J. .

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2006, 441 (1-2) :39-48

[9] Composition of β′ precipitates in Al-Mg-Si alloys by atom probe tomography and first principles calculations [J].

Hasting, Hakon S. ;

Froseth, Anders G. ;

Andersen, Sigmund J. ;

Vissers, Rene ;

Walmsley, John C. ;

Marioara, Calin D. ;

Danoix, Frederic ;

Lefebvre, Williams ;

Holmestad, Randi .

JOURNAL OF APPLIED PHYSICS, 2009, 106 (12)

[10]

Kolar M., 2011, THESIS NORWEGIAN U S

← 1 2 3 →