The Effect of Size and Shape of Austenite Grains on the Mechanical Properties of a Low-Alloyed TRIP Steel

The effects of size and shape of austenite grains on the extraordinary hardening of steels with transformation induced plasticity (TRIP) have been studied. The deformation and transformation of austenite was followed by interrupted ex situ bending tests using electron backscatter diffraction (EBSD) in a scanning electron microscope (SEM). A finite element model (FEM) was used to relate the EBSD based results obtained in the bending experiments to the hardening behavior obtained from tensile experiments. The results are interpreted using a simple rule of mixture for stress partitioning and a short fiber reinforced composite model. It is found that both, the martensite transformation rate and the flow stress difference between austenite and martensite significantly influence the hardening rate. At the initial stage of deformation mainly larger grains deform, however, they do not reach the same strain level as the smaller grains because they transform into martensite at an early stage of deformation. A composite model was used to investigate the effect of grain shape on load partitioning. The results of the composite model show that higher stresses develop in more elongated grains. These grains tend to transform earlier as it is confirmed by the EBSD observations.