Numerical investigation of flow and heat transfer in a volumetric solar receiver

Volumetric solar receivers are used in solar power plants to convert concentrated solar radiation into high temperature heat to operate a thermal engine. In general, porous high temperature materials are used for this purpose. Since the pore geometry is important for the efficiency performance of the receiver, current R&D activities focus on the optimization of this quantity. In this study, the influence of slight geometry changes of this component on its temperature distribution and efficiency has been investigated with the objective of an overall improvement. A numerical analysis of the mass and heat transfer through the receiver has been performed. The investigated receiver was an extruded honeycomb structure made out of Silicon Carbide. Additionally, experimental tests have been performed. In these tests, selected receiver samples have been exposed to concentrated radiation. From these tests solar-to-thermal efficiency data have been derived, which could be compared with the calculated data. Two numerical models have been developed. One makes use of the real geometry of the channel (single channel model), the other one considers the receiver to be "porous continuum", which is described by homogenized properties such as permeability and effective heat conductivity. The experimental parameters such as the average solar heat flux and the mass flow were taken into account in the models as boundary conditions. Various quantities such as the average air outlet temperatures, the temperature distributions and the solar-to-thermal efficiency were used for the comparison. The correspondence between the experimental and numerical results of both numerical models confirms the capability of the approaches for further studies. (C) 2013 Elsevier Ltd. All rights reserved.