A new model of urban cooling demand and heat island application to vertical greenery systems (VGS)

The relationship between Urban Heat Island (UHI) and energy consumption in buildings has been widely observed and studied. The aim of this paper is to investigate the impact of large-scale deployment of indirect Vertical Greenery Systems (VGS) on the cooling demand of buildings and on the urban micro climate. VGS significantly reduces air temperature and wind speed near the walls. In doing so, it also positively impacts the UHI intensity. This is achieved mainly through the conversion of sensible heat to latent heat mediated by evaporation and transpiration from the VGS foliage. Evapotranspiration is a physically complex phenomenon and its interaction with the building and the urban climate is difficult to model accurately. We propose to use a dynamic nonlinear lumped parameter thermal network model to determine the thermal interactions between the prototypical building, the VGS, the paved road, the urban canopy air and the atmosphere. The model accounts for both sensible and latent exchanges within and outside the building. Solar (short-wave) radiation on building fa ade and road accounts for shading and unlimited diffuse reflections. Long-wave radiation among surfaces and between surfaces and the sky are estimated using view factors and the fully nonlinear Stefan-Bolzmann law. Building envelope infiltration rate and convective heat transfer coefficient vary with wind speed so as to properly reflect the energetic impact of wind speed attenuation near the wall due to the foliage. The thermal and aerodynamic characterization of the vegetation is based on the formulations proposed by Deardorff (1978). The evapotranspiration rate is estimated based on the Penman formula and is driven by the 'vapor pressure deficit' between actual vapor pressure in the ambient air and the saturation vapor pressure assumed to prevail on the surface of leaves. The calculation of sensible and latent heat fluxes between the urban canopy and the first level of the atmosphere considers buoyancy effects, using the coefficients introduced by Mascart et al. (1995). First, a base case model (no VGS) is created and validated using both building energy consumption data and urban air temperature measurements. The validated model is then used to investigate the impact of a large-scale deployment of VGS in the urban context. The weather data and the typical building thermo-physical properties are from the UAE. Comparison of the urban base case to the rural base case (both without VGS) shows a cooling load penalty, due to the UHI, of about 7%. Retrofitting VGS to all buildings in the urban domain of study results in a 5 8% reduction of the cooling load and a dramatic drop of the urban air temperature of about 0.7 0.9 C, reducing the UHI intensity by almost half. (C) 2017 Elsevier B.V. All rights reserved.