Defluidization conditions for a fluidized bed of iron oxide-, nickel oxide-, and manganese oxide-containing oxygen carriers for chemical-looping combustion

For combustion with CO2 capture, chemical-looping combustion with inherent separation Of CO2 is a promising technology. Chemical-looping combustion uses oxygen carriers that are composed of metal oxide to transfer oxygen from the combustion air to the fuel. The defluidization of oxygen-carrier particles was investigated to improve the understanding of when particle agglomeration may occur. The study was made in a laboratory fluidized-bed reactor at 950 degrees C, simulating a chemical-looping combustion system by exposing the sample to reducing and oxidizing conditions in an alternating manner. The oxygen-carrier particles used were based on oxides of iron, nickel, and manganese and produced by freeze granulation. For iron oxide particles, there was no defluidization of the bed when the content of available oxygen in the particle was high. The defluidization occurred during the oxidation period after long reduction periods, in which a significant reduction of the magnetite to wustite occurred. This is an important observation, because the reduction to wustite is not expected in chemical-looping combustion with high fuel conversion. Thus, laboratory experiments with iron oxide performed with long reduction times may give an unduly exaggerated impression of the risks of agglomeration. For nickel oxide, the defluidization was dependent on the sintering temperature with no defluidization in experiments conducted with particles sintered at 1300 and 1400 degrees C. The nickel oxide particles that were sintered at 1500 degrees C only defluidized once in a total of 49 cycles, whereas the particles that were sintered at 1600 degrees C defluidized already in the first cycle. For the nickel oxide particles, it was not possible to see any effect of the length of the reducing period on the defluidization. There was no defluidization of the manganese oxide particles. The defluidization of the bed leads to agglomeration for the iron oxide particles, but not for the particles of nickel oxide, where the bed was still loosely packed. Carbon was formed on the particles based on nickel oxide and manganese oxide.