Effect of Al2O3 coating on fretting wear performance of Zr alloy

被引：40

作者：

Lorenzo-Martin, C. ^{[1
]}

Ajayi, O. O. ^{[1
]}

Hartman, K. ^{[1
]}

Bhattacharya, S. ^{[1
]}

Yacout, A. ^{[1
]}

机构：

[1] Argonne Natl Lab, Argonne, IL 60439 USA

来源：

WEAR | 2019年 / 426卷

关键词：

ALD; Fretting; Wear; Alumina; Zirlo; BEHAVIOR; ENERGY; DAMAGE; TEMPERATURE; THICKNESS; CORROSION; FILMS;

D O I：

10.1016/j.wear.2018.12.024

中图分类号：

TH [机械、仪表工业];

学科分类号：

0802 ;

摘要：

Fretting wear caused by flow-induced vibration (FIV) is one of the predominant tribological failure modes in nuclear power plants and industry. This paper presents an experimental study of the effect on fretting performance of alumina (Al2O3) coatings produced by atomic layer deposition (ALD) on Zirlo (a Zr alloy), a common nuclear fuel cladding alloy. A coating with uniform thickness of about 750 nm was deposited onto a Zirlo flat. Because the typical thickness of fuel cladding is 1 mm, an ultra-thin coating is required. The hardness and elastic modulus of the ALD coating were measured by nano-indentation techniques. With a pin-on-flat contact configuration in low-amplitude reciprocating contact, fretting performance was measured for uncoated Zirlo, Al2O3-coated Zirlo, and Al2O3-coated Zirlo followed by heat treatment. Results showed that the as-deposited Al2O3 coating provided slight improvement in fretting wear performance. However, the heat-treated coating showed two orders of magnitude reduction in fretting wear of the Zr alloy. Wear in the uncoated material involves some local plastic deformation and debris accumulation at the contact interface. In the Al2O3-coated material, wear occurred by transfer of transparent Al2O3 oxide into the steel pin counterface. Localized removal of coating from the Zirlo alloy flat resulted in a "shark whale" pattern in a scanning electron microscopy image. There was minimal debris accumulation with the heat-treated sample.

引用

页码：219 / 227

页数：9