Experimental and numerical study of heat transfer from a heated flat plate in a rectangular channel with an impinging air jet

被引:34
作者
Kilic, Mustafa [1 ]
Calisir, Tamer [2 ]
Baskaya, Senol [2 ]
机构
[1] Adana Sci & Technol Univ, Dept Mech Engn, Adana, Turkey
[2] Gazi Univ, Dept Mech Engn, Ankara, Turkey
关键词
Impinging jet; Heat transfer; Channel; Flat plate; CFD; IN-LINE ARRAYS; CIRCULAR JETS; SPENT AIR; STREAMWISE PITCH; NUSSELT NUMBER; CROSS-FLOW; IMPINGEMENT; SURFACE; SIMULATIONS; MODELS;
D O I
10.1007/s40430-016-0521-y
中图分类号
TH [机械、仪表工业];
学科分类号
0802 ;
摘要
Thermal control of electronic components is a continuously emerging problem as power loads keep increasing. To solve these thermal problems impinging jets are generally used in engineering, science and industry for its good heat transfer performance. In this study; cooling of a flat plate under constant heat flux condition, inside a rectangular channel, consisting of one open and three blocked sides was experimentally and numerically investigated using a single air jet flow. The impingement surface was a copper plate of the same width as the jet nozzle. Inlet flow velocities were measured using a Laser Doppler Anemometer (LDA) system. Temperature measurements were performed using thermocouples. Local and mean Nu numbers were determined as a function of two parameters, (a) Jet-to-plate distance (H/D (h)) in the range of 4-10 and (b) Reynolds number based on the hydraulic diameter of the slot nozzle in the range of 4000-10,000 (corresponding to an exit jet velocity from 6.5 to 16.2 m/s). Numerical investigation was also performed. Low Re number k-epsilon turbulence model was used during investigations. The results are presented in the form of graphs showing the variation of the local Nusselt number as a function of these parameters. The effect of Re number on local Nu number was examined for qaEuro(3) = 1000 W/m(2) and H/D (h) = 6. In general, it was observed that heat transfer is sensitive to the Reynolds number and increases with increasing Re number. Average Nusselt number increases of 49.5 % from Re = 4000 to Re = 10000. Effect of H/D (h) on heat transfer under impinging air jets was examined with local Nusselt numbers. Local Nusselt number was less sensitive to H/D (h) in the range of H/D (h) = 4-10. Average Nusselt number decreases of 17.9 % from H/D (h) = 4 to H/D (h) = 10. The highest average Nu number was achieved for Re = 10,000 and H/D (h) = 4. The numerical results agreed well with the experimental data, including local and average Nusselt numbers. Correlations are proposed to predict the local Nusselt number as a function of Re number and H/D (h.).
引用
收藏
页码:329 / 344
页数:16
相关论文
共 48 条
[21]   Numerical investigation of turbulent impinging jet cooling of a constant heat flux surface [J].
Isman, M. K. ;
Pulat, E. ;
Etemoglu, A. B. ;
Can, M. .
NUMERICAL HEAT TRANSFER PART A-APPLICATIONS, 2008, 53 (10) :1109-1132
[22]   A REVIEW OF HEAT-TRANSFER DATA FOR SINGLE CIRCULAR JET IMPINGEMENT [J].
JAMBUNATHAN, K ;
LAI, E ;
MOSS, MA ;
BUTTON, BL .
INTERNATIONAL JOURNAL OF HEAT AND FLUID FLOW, 1992, 13 (02) :106-115
[23]   Impingement cooling in a rib-roughened channel with cross-flow [J].
Jia, RG ;
Rokni, M ;
Sundén, B .
INTERNATIONAL JOURNAL OF NUMERICAL METHODS FOR HEAT & FLUID FLOW, 2001, 11 (07) :642-662
[24]   NUMERICAL INVESTIGATION OF CONFINED MULTIPLE-JET IMPINGEMENT COOLING OVER A FLAT PLATE AT DIFFERENT CROSSFLOW ORIENTAIONS [J].
Miao, Jr-Ming ;
Wu, Chen-Yuan ;
Chen, Ping-Hei .
NUMERICAL HEAT TRANSFER PART A-APPLICATIONS, 2009, 55 (11) :1019-1050
[25]   Jet impingement on a dimpled surface with different crossflow schemes [J].
Kanokjaruvijit, K ;
Martinez-Botas, RF .
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2005, 48 (01) :161-170
[26]   INFLUENCE OF STREAMWISE PITCH ON LOCAL HEAT TRANSFER DISTRIBUTION FOR IN-LINE ARRAYS OF CIRCULAR JETS WITH SPENT AIR FLOW IN TWO OPPOSITE DIRECTIONS [J].
Katti, V. ;
Prabhu, S. V. .
EXPERIMENTAL HEAT TRANSFER, 2009, 22 (04) :228-256
[27]   Influence of spanwise pitch on local heat transfer distribution for in-line arrays of circular jets with spent air flow in two opposite directions [J].
Katti, Vadiraj ;
Prabhu, S. V. .
EXPERIMENTAL THERMAL AND FLUID SCIENCE, 2008, 33 (01) :84-95
[28]   Influence of streamwise pitch on the local heat transfer characteristics for in-line arrays of circular jets with crossflow of spent air in one direction [J].
Katti, Vadiraj ;
Prabhu, S. V. .
HEAT AND MASS TRANSFER, 2009, 45 (09) :1167-1184
[29]   The role of jet inlet geometry in impinging jet heat transfer, modeling and experiments [J].
Koseoglu, M. F. ;
Baskaya, S. .
INTERNATIONAL JOURNAL OF THERMAL SCIENCES, 2010, 49 (08) :1417-1426
[30]   Experimental and numerical simulation study of heat transfer due to confined impinging circular jet [J].
Li Chang-geng ;
Zhou Jie-min .
CHEMICAL ENGINEERING & TECHNOLOGY, 2007, 30 (10) :1355-1361