Comparison Studies of Electrical Discharge Machining (EDM) Process Model for Low Gap Current

被引：13

作者：

Yahya, Azli ^{[1
]}

Andromeda, Trias ^{[1
]}

Minhat, Ade Erawan ^{[1
]}

Khamis, Nor Hisham ^{[1
]}

Kalil, Kamal ^{[1
]}

Rahim, Muhammad Arif Abdul ^{[1
]}

机构：

[1] Fac Elect Engn, Skudai, Johor, Malaysia

来源：

MATERIALS SCIENCE AND INFORMATION TECHNOLOGY, PTS 1-8 | 2012年 / 433-440卷

关键词：

Electrical Discharge Machining; Dimensional Analysis; Artificial Neural Network; MRR; FUZZY-LOGIC; OPTIMIZATION;

D O I：

10.4028/www.scientific.net/AMR.433-440.650

中图分类号：

TP39 [计算机的应用];

学科分类号：

081203 ; 0835 ;

摘要：

This paper aims to compare the material removal rate, (v) over dot between a Dimensional Analysis (DA) model, an Artificial Neural Network (ANN) model and an experimental result for a low gap current of an Electrical Discharge Machining (EDM) process. The data analysis is based on a copper electrode and steel workpiece materials. The DA and ANN model that have been developed and reported earlier by authors are used to compare the material removal of EDM process. The result indicated that the ANN model provides better accuracy towards the experimental results.

引用

页码：650 / 654

页数：5

共 25 条

[1] Andromeda T, 2010, ICEM2010 KUAL LUMP M
[2] Behrens A, 1998, 12 INT S EL GERM, P149
[3] The study of high efficiency and intelligent optimization system in EDM sinking processl
Cao, FG
Yang, DY
[J]. JOURNAL OF MATERIALS PROCESSING TECHNOLOGY, 2004, 149 (1-3) : 83 - 87
[4] Douglas J. F, INTRO DIMENSIONAL AN
[5] Haykin S., 1999, Neural Networks: A Comprehensive Foundation, DOI DOI 10.1017/S0269888998214044
[6] State of the art electrical discharge machining (EDM)
Ho, KH
Newman, ST
[J]. INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE, 2003, 43 (13) : 1287 - 1300
[7] Imai Y, 1998, VDI BERICHT, V1405, P321
[8] Kamlakar P. R, 1997, INT J ELEC MACH, V2, P1
[9] Klocke F, 1998, VDI BERICHT, V1405, P163
[10] Kocher M, P ISEM 11 LAUS, VXI, P105

← 1 2 3 →