Enhanced fatigue behavior of powder metallurgy Ti-6A1-4V alloy by applying ultrasonic impact treatment

The effect of severe plastic deformation induced by multiple sliding impacts by the specimen surface produced at ultrasonic impact treatment (UIT) on the stress-controlled fatigue response of the powder metallurgy Ti-6A1-4V alloy is studied in this paper. Specimens of Ti-6A1-4V alloy were produced from Ti hydride precursor powders via the cost-effective blended elemental powder metallurgy technique. Structure investigations were performed by XRD, TEM, LM and SEM techniques. After UIT, fatigue strength was increased by about 60% on the base of 10(7) cycles, and lifetime was prolonged by two orders of magnitude at applied stress amplitudes of 300400 MPa. The UIT process leads to approx. four times decrease in the surface roughness parameters. Increased by 65 and 20% microhardeness magnitudes are respectively registered on the top surface and on the depth of 100 gm. The UIT induced compressive stresses achieve about two thirds of the alloy yield stress. The hardness increase is shown to be coupled with the increased dislocation density, essentially refined of alpha+beta microstructure and with randomization in alpha-grains orientations. Observations of cross-sections of the UIT processed specimens revealed the pores free near-surface layer of approx. 200 pm thick, which is formed thanks to micro-pore closure process promoted by high shear strains produced at the UT induced sliding impacts. Analysis of fracture surfaces revealed subsurface cracks initiations and numerous fracture steps indicating on the cracks branching and deflection in the surface layers of the UIT processed specimens instead of superficial crack initiation and the grain boundary cleavages mainly observed in the pristine samples. Experimentally registered magnitudes of fatigue limit were successfully predicted by accounting for the effective stress intensity factor range Delta K-th and observed by TEM microstructural units responsible for fatigue fracture (a-phase colonies, a-grains or micro-pores) and compared with literature data on pm Ti-6A1-4V alloy. Enhanced fatigue strength and prolonged lifetime of PM Ti-6A1-4V alloy after the UIT process are concluded to be associated with (i) minimized surface roughness; (ii) compressive residual stresses; (iii) UFG and nano-scale alpha+beta microstructure; and (iv) micro-pore healing. (C) 2015 Published by Elsevier B.V.