Microstructural Evolution in High Purity Titanium Sheet Subjected to Continuous Cyclic Bending and Subsequent Temperature Gradient Annealing

被引:1
作者
Takayama, Yoshimasa [1 ]
Tanaka, Kohei [1 ,2 ]
Watanabe, Hideo [1 ]
机构
[1] Utsunomiya Univ, Grad Sch Engn, Dept Mech & Intelligent Engn, Utsunomiya, Tochigi 3218585, Japan
[2] Calson Kansei Corp, Saitama, Japan
关键词
temperature gradient annealing; titanium; continuous cyclic bending; texture; EBSD analysis; TEXTURE;
D O I
10.2320/jinstmet.JC201704
中图分类号
TF [冶金工业];
学科分类号
0806 ;
摘要
Temperature gradient annealing has been applied to high purity titanium sheet to investigate microstructural and textural evolutions. The annealing with high temperature gradient was performed through a specially designed apparatus for the titanium sheet subjected to continuous cyclic bending (CCB). EBSD analysis revealed characteristic microstructure on cross. section consisting of coarse grained triangular area, in which coarse grains formed inside deeplier at higher temperature side, resulting from higher stored strain and higher temperature annealing, and non. recrystallized fine grained area held at lower temperature. Textural evolution was also examined for the CCBent and annealed titanium sheets. Further, effects of the temperature gradient annealing were discussed.
引用
收藏
页码:547 / 554
页数:8
相关论文
共 18 条
[1]   ORIENTATION IMAGING - THE EMERGENCE OF A NEW MICROSCOPY [J].
ADAMS, BL ;
WRIGHT, SI ;
KUNZE, K .
METALLURGICAL TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 1993, 24 (04) :819-831
[2]  
Bocquet JL, 1996, Physical Metallurgy, VFourth, P535
[3]  
Humphreys J. F., 2004, RECRYSTALLIZATION RE, P220
[4]  
Inoue H., 1999, METALS-BASEL, V69, P30
[5]  
Inoue H., 1990, P INT C RECR MET MAT, P687
[6]  
Japan Inst. Metals, 1993, METALS DATA BOOK, P13
[7]   DEVELOPMENT OF THE ROLLING TEXTURE IN TITANIUM [J].
LEE, HP ;
ESLING, C ;
BUNGE, HJ .
TEXTURES AND MICROSTRUCTURES, 1988, 7 (04) :317-337
[8]   UNIDIRECTIONAL RECRYSTALLIZATION IN COLD-SWAGED NI OVER A WIDE-RANGE OF TEMPERATURE-GRADIENT [J].
MIURA, I ;
HAMANAKA, H .
JOURNAL OF THE JAPAN INSTITUTE OF METALS, 1978, 42 (03) :260-266
[9]  
Sangdahl G.S., 1948, Proceedings of the Society of Experimental Stress Analysis, V6, P1
[10]   Microstructural and textural evolution by continuous cyclic bending and annealing in a high purity titanium [J].
Takayama, Y ;
Miura, T ;
Kato, H ;
Watanabe, H .
MATERIALS TRANSACTIONS, 2004, 45 (09) :2826-2831