Influence of the Spray Gun Type on Microstructure and Properties of HVAF Sprayed Fe-Based Corrosion Resistant Coatings

被引：19

作者：

Milanti, A. ^{[1
]}

Koivuluoto, H. ^{[1
]}

Vuoristo, P. ^{[1
]}

机构：

[1] Tampere Univ Technol, Dept Mat Sci, Tampere 33720, Finland

来源：

JOURNAL OF THERMAL SPRAY TECHNOLOGY | 2015年 / 24卷 / 07期

关键词：

corrosion behavior; Fe-based coatings; HVAF; structure; STAINLESS-STEEL COATINGS; SLIDING WEAR BEHAVIOR; HVOF; PARAMETERS; POWDER; NACL;

D O I：

10.1007/s11666-015-0298-z

中图分类号：

TB3 [工程材料学];

学科分类号：

0805 ; 080502 ;

摘要：

The aim of this study is to evaluate the microstructural details and corrosion properties of novel Fe-based coatings prepared using two different generations of HVAF spray guns. These two generations of HVAF guns are Activated Combustion HVAF (AC-HVAF, 2nd generation) M2 gun and Supersonic Air Fuel HVAF (SAF, 3rd generation) M3 gun. Structural details were analysed using x-ray diffractometry and field-emission scanning electron microscope. Higher denseness with homogeneous microstructure was achieved for Fe-based coating deposited by the M3 process. Such coatings exhibit higher particle deformation and lower oxide content compared to coatings manufactured with M2 gun. Corrosion properties were studied by open-cell potential measurements and electrochemical impedance spectroscopy. The lower porosity and higher interlamellar cohesion of coating manufactured with M3 gun prevent the electrolyte from penetrating through the coating and arriving to the substrate, enhancing the overall corrosion resistance. This can be explained by the improved microstructures and coating performance.

引用

页码：1312 / 1322

页数：11

共 32 条

[1]

[Anonymous], 2011, COB TUNGST CARB POWD

[2]

Berger L-M., 2013, THERM SPRAY B, V6, P16

[3] Hardmetals as thermal spray coatings [J].

Berger, Lutz-Michael .

POWDER METALLURGY, 2007, 50 (03) :205-214

[4] Effect of heat treatment on the microstructure and mechanical properties of Fe-based amorphous coatings [J].

Bin-you, Fu ;

Ding-yong, He ;

Li-dong, Zhao .

JOURNAL OF ALLOYS AND COMPOUNDS, 2009, 480 (02) :422-427

[5] Cermet coatings with Fe-based matrix as alternative to WC-CoCr: Mechanical and tribological behaviours [J].

Bolelli, Giovanni ;

Boerner, Tim ;

Bozza, Francesco ;

Cannillo, Valeria ;

Cirillo, Gennaro ;

Lusvarghi, Luca .

SURFACE & COATINGS TECHNOLOGY, 2012, 206 (19-20) :4079-4094

[6] Micromechanical properties and sliding wear behaviour of HVOF-sprayed Fe-based alloy coatings [J].

Bolelli, Giovanni ;

Bonferroni, Benedetta ;

Laurila, Jussi ;

Lusvarghi, Luca ;

Milanti, Andrea ;

Niemi, Kari ;

Vuoristo, Petri .

WEAR, 2012, 276 :29-47

[7]

[Bose S. BH BH], 2007, HIGH TEMPERATURE COA, P299

[8] Investigation of scuffing damage in aluminum engines with thermal spray coatings [J].

Edrisy, A ;

Perry, T ;

Alpas, AT .

WEAR, 2005, 259 :1056-1062

[9] Wear of thermal spray deposited low carbon steel coatings on aluminum alloys [J].

Edrisy, A ;

Perry, T ;

Cheng, YT ;

Alpas, AT .

WEAR, 2001, 251 (PART 2) :1023-1033

[10] Repassivation of the damage generated by cavitation on UNS N08031 in a LiBr solution by means of electrochemical techniques and Confocal Laser Scanning Microscopy [J].

Fernandez-Domene, R. M. ;

Blasco-Tamarit, E. ;

Garcia-Garcia, D. M. ;

Garcia-Anton, J. .

CORROSION SCIENCE, 2010, 52 (10) :3453-3464

← 1 2 3 4 →