Room temperature equal-channel angular pressing of a magnesium alloy

Equal-channel angular pressing (ECAP) of magnesium alloy Mg-3Al-1Zn (wt.%) has been carried out at room temperature by applying a back-pressure three times larger than the yield stress in a 90 degrees die. In a single pass, the initial grain size of similar to 10 mu m originating from twin-roll casting was reduced down to similar to 3 mu m. {1 0 (1) over bar 2} tensile twins were observed by orientation imaging up to similar to 40% volume fraction in grains that remained relatively high after ECAP. Regions with small grain size did not show twinning. The small lattice curvatures indicated that dynamic recovery/recrystallization took place during testing. The 90 degrees ECAP deformation field was approximated by two-stage simple shear due to a large dead metal zone appearing at the outer corner of the die. Using this strain path, the viscoplastic self-consistent (VPSC) model was employed to model the texture evolution in the version where a parameter (alpha) tunes the interaction equation between a grain and the homogeneous equivalent medium. The textures were reproduced in good accord with experiments only if the alpha parameter corresponded to the Tangent VPSC model. Twinning was simulated in a quantitative way by introducing the volume transfer scheme in the VPSC model without employing a criterion for selection of the six possible twin variants. (c) 2013 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.