Effects of split injection proportion and the second injection timings on the combustion and emissions of a dual fuel SI engine with split hydrogen direct injection

被引:33
|
作者
Li, Guanting [1 ]
Yu, Xiumin [1 ]
Shi, Weibo [1 ]
Yao, Chuanzhao [1 ]
Wang, Sen [1 ]
Shen, Qingxu [1 ]
机构
[1] Jilin Univ, State Key Lab Automot Simulat & Control, Renmin St 5988, Changchun 130022, Jilin, Peoples R China
基金
中国国家自然科学基金;
关键词
Dual-fuel engine; Combined injection; Hydrogen direct-injection; Split injection; Combustion; Emission; GDI ENGINE; PERFORMANCE; STRATEGY; DIESEL;
D O I
10.1016/j.ijhydene.2019.02.222
中图分类号
O64 [物理化学(理论化学)、化学物理学];
学科分类号
070304 ; 081704 ;
摘要
In this paper, a new kind of injection mode, split hydrogen direct injection, was presented for a dual fuel SI engine. Six different first injection proportions (IP1) and five different second injection timings were applied at the condition of excess air ratio of 1, first injection timing of 300 degrees CA BTDC, low speed, low load conditions and the Minimum spark advance for Best Torque (MBT) on a dual fuel SI engine with hydrogen direct injection (HDI) plus port fuel injection (PFI). The result showed that, split hydrogen direct injection can achieve a higher brake thermal efficiency and lower emissions compared with single HDI. In comparison with single HDI, the split hydrogen direct injection can form a controlled stratified condition of hydrogen which could make the combustion more complete and faster. By adding an early spray to form a more homogeneous mixture, the split hydrogen direct injection not only can help to form a flame kernel to make the combustion stable, but also can speed up the combustion rate through the whole combustion process, which can improve the brake thermal efficiency. By split hydrogen direct injection, the torque reaches the highest when the first injection proportion is 33%, which improves by 1.13% on average than that of single HDI. With the delay of second injection timing, the torque increases first and then decreases. With the increase of first injection proportion, the best second injection timing is advanced. Furthermore, by forming a more homogeneous mixture, the split hydrogen direct injection can reduce the quenching distance to reduce the HC emission and reduce the maximum temperature to reduce the NOx. The split hydrogen direct injection can reduce the HC emission by 35.8%, the NOx emissions by 7.3% than that of single HDI. (C) 2019 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.
引用
收藏
页码:11194 / 11204
页数:11
相关论文
共 50 条
  • [31] Evaluation of performances in DI Diesel engine with different split injection timings
    Balamurugan G.
    Gowthaman S.
    Energy Harvesting and Systems, 2024, 11 (01)
  • [32] Impact of split injection strategy on combustion, performance and emissions characteristics of biodiesel fuelled common rail direct injection assisted diesel engine
    Babu, D.
    Karvembu, R.
    Anand, R.
    ENERGY, 2018, 165 : 577 - 592
  • [33] EFFECT OF DIESEL INJECTION SPLIT ON COMBUSTION AND EMISSIONS PERFORMANCE OF A NATURAL GAS - DIESEL DUAL FUEL ENGINE AT A LOW LOAD CONDITION
    Guo, Hongsheng
    Liko, Brian
    Neil, W. Stuart
    PROCEEDINGS OF THE ASME INTERNAL COMBUSTION ENGINE FALL TECHNICAL CONFERENCE, 2017, VOL 1, 2017,
  • [34] Improvements of Combustion and Emissions in a Natural Gas Fueled Engine with Hydrogen Enrichment and Optimized Injection Timings of the Diesel Fuel
    Kobashi Y.
    Inagaki R.
    Shibata G.
    Ogawa H.
    SAE International Journal of Advances and Current Practices in Mobility, 2022, 5 (05): : 1709 - 1718
  • [35] FUEL INJECTION SPLIT MODEL FOR DIESEL ENGINE ADVANCED COMBUSTION MODE CONTROL
    Yan, Fengjun
    Wang, Junmin
    PROCEEDINGS OF THE ASME 5TH ANNUAL DYNAMIC SYSTEMS AND CONTROL DIVISION CONFERENCE AND JSME 11TH MOTION AND VIBRATION CONFERENCE, DSCC 2012, VOL 2, 2012, : 313 - 319
  • [36] Effects of hydrogen injection timing and injection pressure on mixture formation and combustion characteristics of a hydrogen direct injection engine
    Huang, Zeyuan
    Yuan, Shuang
    Wei, Hong
    Zhong, Lijia
    Hu, Zhen
    Liu, Zongkuan
    Liu, Changwen
    Wei, Haiqiao
    Zhou, Lei
    FUEL, 2024, 363
  • [37] Performance and combustion characteristics of a direct injection SI hydrogen engine
    Mohammadi, Ali
    Shioji, Masahiro
    Nakai, Yasuyuki
    Ishikura, Wataru
    Tabo, Eizo
    INTERNATIONAL JOURNAL OF HYDROGEN ENERGY, 2007, 32 (02) : 296 - 304
  • [38] Effects of engine operating parameters on diesel low-temperature combustion with split fuel injection
    Sarangi, Asish K.
    Garner, Colin P.
    McTaggart-Cowan, Gordon P.
    Davy, Martin H.
    Wahab, Emad
    Peckham, Mark S.
    PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART D-JOURNAL OF AUTOMOBILE ENGINEERING, 2012, 226 (D9) : 1271 - 1286
  • [39] Combustion performance and stability in dual fuel engine with different pilot diesel injection timings
    Sun, Lu
    Liu, Yifu
    Zeng, Ke
    Hsi-An Chiao Tung Ta Hsueh/Journal of Xi'an Jiaotong University, 2014, 48 (07): : 29 - 33
  • [40] A study on split diesel injection on thermal efficiency and emissions of an ammonia/diesel dual-fuel engine
    Yousefi, Amin
    Guo, Hongsheng
    Dev, Shouvik
    Lafrance, Simon
    Liko, Brian
    FUEL, 2022, 316