Effect of Type and Interconnection of DG Units in the Fault Current Level of Distribution Networks

被引：14

作者：

Baghaee, H. R. ^{[1
]}

Mirsalim, M. ^{[1
]}

Sanjari, M. J. ^{[1
]}

Gharehpetian, G. B. ^{[1
]}

机构：

[1] Amirkabir Univ Technol, Ctr Excellence Power Engn, Tehran, Iran

来源：

2008 13TH INTERNATIONAL POWER ELECTRONICS AND MOTION CONTROL CONFERENCE, VOLS 1-5 | 2008年

关键词：

Distributed Generation; Distribution System; Fault Current; Power Electronic;

D O I：

10.1109/EPEPEMC.2008.4635284

中图分类号：

TP [自动化技术、计算机技术];

学科分类号：

0812 ;

摘要：

Fundamental requirements for the connection of distributed generation resources to the network are not only power quality constraints, but also voltage regulation and the total fault level, which should remain below the network desired value. This constraint is often the main limiting factor for the interconnection of these resources units to the grids. In the presented paper, the impact of installation of distributed resources in the distribution systems from the perspective of increase in the fault contribution will be discussed and comparative study will be performed to analyze the effect of type and interconnection of distributed generation unit on the fault current contribution of the distribution systems. Simulation results indicate that the increase in fault currents is often greater in the synchronous machine implementation versus a comparable inverter based design.

引用

页码：313 / 319

页数：7

共 31 条

[1]

Ackermann T, 2002, IEEE/PES TRANSMISSION AND DISTRIBUTION CONFERENCE AND EXHIBITION 2002: ASIA PACIFIC, VOLS 1-3, CONFERENCE PROCEEDINGS, P1357, DOI 10.1109/TDC.2002.1177677

[2]

ACKERMANN T, 2001, ELSEVIER ELECT POWER, V57, P894

[3]

[Anonymous], 15472003 IEEE

[4]

[Anonymous], 2001, 609090 IEC

[5]

[Anonymous], 2003, 609093 IEC

[6]

[Anonymous], 2002, 609091 IEC

[7]

[Anonymous], 2000, 609094 IEC

[8]

Barker PP, 2000, 2000 IEEE POWER ENGINEERING SOCIETY SUMMER MEETING, CONFERENCE PROCEEDINGS, VOLS 1-4, P1645, DOI 10.1109/PESS.2000.868775

[9] SHORT-CIRCUIT CURRENT CALCULATION - A COMPARISON BETWEEN METHODS OF IEC AND ANSI STANDARDS USING DYNAMIC SIMULATION AS REFERENCE [J].

BERIZZI, A ;

MASSUCCO, S ;

SILVESTRI, A ;

ZANINELLI, D .

IEEE TRANSACTIONS ON INDUSTRY APPLICATIONS, 1994, 30 (04) :1099-1106

[10]

Doyle MT, 2002, 2002 IEEE POWER ENGINEERING SOCIETY SUMMER MEETING, VOLS 1-3, CONFERENCE PROCEEDINGS, P103, DOI 10.1109/PESS.2002.1043186

← 1 2 3 4 →