Structural, electrical and optical properties of K-doped NiO films prepared by rapid pyrolysis sol-gel technique

被引:24
作者
Wang, N. [1 ]
Liu, C. Q. [1 ]
Liu, C. Q. [1 ]
Wen, B. [1 ]
Wang, H. L. [1 ]
Liu, S. M. [1 ]
Jiang, W. W. [1 ]
Ding, W. Y. [1 ]
Chai, W. P. [1 ]
机构
[1] Dalian Jiaotong Univ, Engn Res Ctr Optoelect Mat & Devices, Sch Mat Sci & Engn, Dalian 116028, Peoples R China
关键词
Sol-Gel deposition; Thin films; Transparent conducting oxide; Nickel oxide; Potassium; Doping; Pyrolysis; THIN-FILMS; NICKEL-OXIDE; STRESS DEVELOPMENT; COATINGS; ANODE;
D O I
10.1016/j.tsf.2016.08.051
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
K-doped NiO films (Ni1-xKxO) were deposited on glass substrates using a rapid pyrolysis sol-gel technique. The structural, morphological, electrical and optical properties of the films were investigated using X-ray diffraction, scanning electron microscopy and atomic force microscope, Hall effect measurement system, and ultraviolet-visible spectrophotometer, respectively. All the deposited films were cubic structure, and the residual stress in the films changed with increasing K doping concentration from residual compressive stress to residual tensile stress. The morphologies and compactability of the films were seriously affected by the K doping concentration, and the cause of the formation of the morphologies was discussed detailedly. The lowest root-mean-square roughness of the films was obtained at x = 0.06 and was about 2.6 nm. The carrier concentration of the films was very similar, but the carrier mobility of the films was seriously affected by the compactabiliry of the films. The lowest resistivity of about 23.7 Omega.cm was obtained at x = 0.06. The transmittance decreased on the whole with increasing K doping concentration, but the optical energy bandgaps of the films were almost constant. (C) 2016 Elsevier B.V. All rights reserved.
引用
收藏
页码:587 / 593
页数:7
相关论文
共 18 条
[1]   Fabrication of UV photo-detector based on coral reef like p-NiO/n-ZnO nanocomposite structures [J].
Abbasi, Mazhar Ali ;
Ibupoto, Zafar Hussain ;
Khan, Azam ;
Nur, Omer ;
Willander, Magnus .
MATERIALS LETTERS, 2013, 108 :149-152
[2]   Enhanced hole injections in organic light-emitting devices by depositing nickel oxide on indium tin oxide anode [J].
Chan, IM ;
Hsu, TY ;
Hong, FC .
APPLIED PHYSICS LETTERS, 2002, 81 (10) :1899-1901
[3]   Preparation of a Counter Electrode with P-Type NiO and Its Applications in Dye-Sensitized Solar Cell [J].
Chou, Chuen-Shii ;
Hsiung, Chin-Min ;
Wang, Chun-Po ;
Yang, Ru-Yuan ;
Guo, Ming-Geng .
INTERNATIONAL JOURNAL OF PHOTOENERGY, 2010, 2010
[4]   Electrochromic performance of sol-gel deposited NiO thin film [J].
Dalavi, Dhanaji S. ;
Devan, Rupesh S. ;
Patil, Raghunath S. ;
Ma, Yuan-Ron ;
Patil, Pramod S. .
MATERIALS LETTERS, 2013, 90 :60-63
[5]   Electronic, electrical and optical properties of undoped and Na-doped NiO thin films [J].
Denny, Yus Rama ;
Lee, Kangil ;
Park, Chanae ;
Oh, Suhk Kun ;
Kang, Hee Jae ;
Yang, Dong-Seok ;
Seo, Soonjoo .
THIN SOLID FILMS, 2015, 591 :255-260
[6]   High conductivity nickel oxide thin films by a facile sol-gel method [J].
Guo, Wen ;
Hui, K. N. ;
Hui, K. S. .
MATERIALS LETTERS, 2013, 92 :291-295
[7]   p-Type semiconducting nickel oxide as an efficiency-enhancing anode interfacial layer in polymer bulk-heterojunction solar cells [J].
Irwin, Michael D. ;
Buchholz, Bruce ;
Hains, Alexander W. ;
Chang, Robert P. H. ;
Marks, Tobin J. .
PROCEEDINGS OF THE NATIONAL ACADEMY OF SCIENCES OF THE UNITED STATES OF AMERICA, 2008, 105 (08) :2783-2787
[8]   Electrical properties of Li-doped NiO films [J].
Jang, Wei-Luen ;
Lu, Yang-Ming ;
Hwang, Weng-Sing ;
Chen, Wei-Chien .
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY, 2010, 30 (02) :503-508
[9]   Stress development in drying coatings after solidification [J].
Lei, H ;
Francis, LF ;
Gerberich, WW ;
Scriven, LE .
AICHE JOURNAL, 2002, 48 (03) :437-451
[10]   Double-Layered NiO Photocathodes for p-Type DSSCs with Record IPCE [J].
Li, Lin ;
Gibson, Elizabeth A. ;
Qin, Peng ;
Boschloo, Gerrit ;
Gorlov, Mikhail ;
Hagfeldt, Anders ;
Sun, Licheng .
ADVANCED MATERIALS, 2010, 22 (15) :1759-+