Thermal characterization and kinetic analysis of nesquehonite, hydromagnesite, and brucite, using TG-DTG and DSC techniques

被引:77
作者
Ren, Hongrui [1 ,2 ]
Chen, Zhen [2 ]
Wu, Yulong [2 ,3 ]
Yang, Mingde [2 ]
Chen, Jin [1 ]
Hu, Husheng [2 ]
Liu, Ji [2 ]
机构
[1] Taiyuan Univ Technol, Coll Mat Sci & Engn, Taiyuan 030024, Shanxi, Peoples R China
[2] Tsinghua Univ, Inst Nucl & New Energy Technol, Beijing 100084, Peoples R China
[3] Tsinghua Univ, Beijing Key Lab Fine Ceram, Beijing 100084, Peoples R China
基金
中国国家自然科学基金;
关键词
Nesquehonite; Hydromagnesite; Brucite; TG-DTG; DSC; FT-IR ANALYSIS; DECOMPOSITION KINETICS; CRYSTAL-STRUCTURE; SEA-WATER; MGO; POWDERS; TEMPERATURE; AGGLOMERATION; CARBONATES; EVOLUTION;
D O I
10.1007/s10973-013-3372-0
中图分类号
O414.1 [热力学];
学科分类号
摘要
Nesquehonite, hydromagnesite, and brucite are important precursors for the preparation of high-purity magnesia (MgO) using magnesium resources from salt lake as raw materials. In this paper, TG-DTG and DSC were used to investigate the thermal decomposition behaviors of the three precursors. Decomposition kinetic parameters at each stage were evaluated based on the TG data using the iso-conversional method. Decomposition mechanisms were determined using the master-plots method. The decomposition temperature range, heat absorption, and kinetic parameters of the three phases were then compared. The most probable mechanism of each stage from the perspective of crystal structure was found to be consistent with the calculation results from the master-plots method. Results led to the conclusion that nesquehonite is the most appropriate precursor for the preparation of high-purity MgO. Further studies on precursor selection and calcining condition selection for the preparation of MgO using bischofite will benefit from this research.
引用
收藏
页码:1949 / 1960
页数:12
相关论文
共 28 条
[21]   Characterization of medium and heavy crude oils using thermal analysis techniques [J].
Kok, Mustafa Versan .
FUEL PROCESSING TECHNOLOGY, 2011, 92 (05) :1026-1031
[22]   Using thermal analysis and combined techniques for food characterization - Report on panel presentation [J].
Relkin, P .
JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY, 2005, 80 (03) :799-801
[23]   Thermal analysis of tendon, cartilage and bone samples from shoulder joint replacement patients using differential scanning calorimetry (DSC) and thermogravimetry (DTA/TG) [J].
Lorinczy, Denes ;
Bata, Andras ;
Labas, Zoltan ;
Shafiei, Farid ;
Szabo, Hajnalka ;
Cifra, Janos ;
Not, Laszlo G. .
JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY, 2024, 149 (20) :11471-11483
[24]   Use of coupled TG-DSC-QMS-FTIR thermal analysis techniques in characterizating clays and ceramic compositions used in ceramic tile manufacture.: Quantification of carbon compounds [J].
Gómez, M. P. ;
Gazulla, M. F. ;
Zumaquero, E. ;
Orduña, M. .
BOLETIN DE LA SOCIEDAD ESPANOLA DE CERAMICA Y VIDRIO, 2007, 46 (05) :259-266
[25]   Characterization of poled and non-poled β-PVDF films using thermal analysis techniques [J].
Sencadas, V ;
Lanceros-Méndez, S ;
Mano, JF .
THERMOCHIMICA ACTA, 2004, 424 (1-2) :201-207
[26]   Cure characterization of epoxy and polyester clear powder coatings using Differential Scanning Calorimetry (DSC) and Dynamic Mechanical Thermal Analysis (DMTA) [J].
Mafi, R ;
Mirabedini, SM ;
Attar, MM ;
Moradian, S .
PROGRESS IN ORGANIC COATINGS, 2005, 54 (03) :164-169
[27]   Characterization and distribution of plastic particles along Alexandria beaches, Mediterranean Coast of Egypt, using microscopy and thermal analysis techniques [J].
Ghani, Safaa A. Abdel ;
El-Sayed, Abeer A. M. ;
Ibrahim, Mohamed I. A. ;
Ghobashy, Mohamed Mohamady ;
Shreadah, Mohamed A. ;
Shabaka, Soha .
SCIENCE OF THE TOTAL ENVIRONMENT, 2022, 834
[28]   Kinetic Parameters of PBX Based on Cis-1,3,4,6-tetranitroocta-hydroimidazo-[4,5-d] imidazole Obtained by Isoconversional Methods using Different Thermal Analysis Techniques [J].
Elbeih, Ahmed ;
Abd-Elghany, Mohamed ;
Klapoetke, Thomas M. .
PROPELLANTS EXPLOSIVES PYROTECHNICS, 2017, 42 (05) :468-476