Effect of Nitrogen Doping on the Structure and Mechanical Properties of the Fe40Mn40Cr10Co10 High-Entropy Alloy

The structure and mechanical properties of as-cast and thermomechanicaly processed (cold rolling followed by annealing at 700 degrees C and 900 degrees C) Fe40Mn40Cr10Co10 (at.%) high-entropy alloys doped with different amounts (0, 0.5, and 2.0 at.%) of N were examined. The as-cast Fe40Mn40Cr10Co10 alloy (N0) contained sigma-phase particles at the boundaries of the fcc grains. The addition of 0.5 (N0.5) and 2.0 (N2) at.% of nitrogen suppressed the formation of the sigma-phase due to which the alloys consisted of only the fcc phase. Annealing after rolling resulted in the development of static recrystallization and precipitation of additional phases: the sigma-phase was found in the N0 and N0.5 alloys, and hexagonal M2N nitrides were found in the N2 alloy. The strength of the as-cast alloys at room temperature increased with increasing nitrogen concentration due to interstitial solid solution strengthening. Cold rolling and subsequent annealing resulted in considerable strengthening of the program alloys. The strength of the alloys increased with the N content and decreased with increasing annealing temperature. The best combination of mechanical properties at room temperature was attained in the N2 alloy after annealing at 700 degrees C, and at 77 K, was demonstrated by the N0.5 alloy after annealing at 900 degrees C.