Treatment of oil and grease in produced water by a pilot-scale constructed wetland system using biogeochemical processes

Constructed wetland treatment systems (CWTSs) can effectively remove many constituents that limit beneficial use of oilfield produced water. The objectives of this investigation were: (1) to assess the effect of mass loadings of oil and grease (O & G) on treatment performance in pilot-scale subsurface flow and free water surface CWTS series having sequential reducing and oxidizing cells, and (2) to evaluate effects on treatment performance of adding a pilot-scale oil-water separator. Increase in O & G mass loading from 5 to 20 mg min(-1) caused decreases in both dissolved oxygen concentration and sediment redox potential, which affected treatment performance. Biogeochemical pathways for removal of O & G, iron, and manganese operate under oxidizing conditions, and removal rate coefficients for these constituents decreased (0.905-0.514 d(-1) for O & G, 0.773-0.452 d(-1) for iron, and 0.970-0.518 d(-1) for manganese) because greater mass loading of O & G promoted reducing conditions. With increased mass loading, removal rate coefficients for nickel and zinc increased from 0.074 to 0.565 d(-1) and from 0.196 to 1.08 d(-1), respectively. Although the sequential reducing and oxidizing cells in the CWTS were very effective in treating the targeted constituents, an oil-water separator was added prior to wetland cells to enhance O & G removal at high inflow concentration (100 mg L-1). The oil-water separator removed approximately 50% of the O & G, and removal extents and efficiencies approximated those observed at 50 mg L-1 inflow concentration during treatment without an oil-water separator. (c) 2013 Elsevier Ltd. All rights reserved.