Development of upsetting-extrusion type tribometer for evaluating lubrication coating performance in cold forging

A new upsetting-extrusion type tribometer has been developed to investigate the performance of the lubrication coating on the side surface of a billet in the multi-stage cold forging. In this tribometer, the lubrication coating is first destroyed by the upsetting process due to the free expansion of the billet surface and then evaluated by the extrusion process. The frictional shear factor of the lubrication coating is obtained by plotting the measured extrusion load and the position after the extrusion of a centerline drawn on the billet in advance on the calibration curve obtained by FEM. Experimental results using a zinc phosphate coating and a dry in-place type coating showed that the reduced peak height Rpk is more appropriate than the maximum height Rz to express the effect of the surface roughness of tool on galling generation. When no galling occurs, the frictional shear factor hardly varies with the type of the lubrication coating and the surface expansion ratio. The anti-galling ability of the dry in-place type coating is greatly improved by a two-stage shot blast before the lubrication coating and reaches a level better than the zinc phosphate coating.