Experimentation, material modelling and simulation of bonded joints with a flexible adhesive

被引：16

作者：

Lubowiecka, I. ^{[1
]}

Rodriguez, M. ^{[1
]}

Rodriguez, E. ^{[1
]}

Martinez, D. ^{[1
]}

机构：

[1] AIMEN Technol Ctr, Porrino 36410, Pontevedra, Spain

来源：

INTERNATIONAL JOURNAL OF ADHESION AND ADHESIVES | 2012年 / 37卷

关键词：

Aluminium and alloys; Destructive testing; Mechanical properties of adhesives; Joint design; Polyurethane; RUBBER;

D O I：

10.1016/j.ijadhadh.2012.01.010

中图分类号：

TQ [化学工业];

学科分类号：

0817 ;

摘要：

The paper deals with material parameters identification of a flexible adhesive and the numerical simulation of its behaviour in a single lap bonded joint. The material modelling was based on the simple shear and tensile-shear laboratory tests of the bonded joints made of thin aluminium and polyurethane plates with the flexible adhesive Terostat MS 9360 (R) manufactured by Henkel AG & Co. The adhesive was considered as a hyperelastic material. The nonlinear analysis of the joints was conducted in ABAQUS (R) finite element program. The experiment and the simulation of a boat fender made of polyurethane with adhesive joints were performed. The test results were used to validate the simulation and the obtained characteristics of the hyperelastic materials. (C) 2012 Elsevier Ltd. All rights reserved.

引用

页码：56 / 64

页数：9

共 21 条

[1]

Ali Aidy, 2010, American Journal of Engineering and Applied Sciences, V3, P232, DOI 10.3844/ajeassp.2010.232.239

[2]

[Anonymous], 2009, Abaqus user's manual version 9.2

[3] A 3-DIMENSIONAL CONSTITUTIVE MODEL FOR THE LARGE STRETCH BEHAVIOR OF RUBBER ELASTIC-MATERIALS [J].